NuTone Clock AHS 200 User Manual

®
INSTALLATION INSTRUCTIONS  
READ & SAVE THESE INSTRUCTIONS!  
Automatic Heat Sensor  
MODEL: AHS-200  
For use with NuTone Attic Ventilators  
The NuTone Model AHS-200 is a 200°F heat  
sensor and is intended to be installed in the attic  
and connected into the power line of a NuTone  
Attic Ventilator. In the event the attic  
MODEL AHS-200  
temperature surrounding the heat sensor  
reaches 200°F (for any reason, including fire),  
THERMOSTAT  
the unit will interrupt power to the ventilator  
and then will be turned off.  
TO 120vAC,  
60 Hz  
1. Located the heat sensor near the Attic  
Ventilator thermostat so that it is up-roof  
from the ventilator and thermostat.  
2. Mount the heat sensor on the side of a roof  
rafter so that it's pointing down toward the  
living area of the home.  
AHS-200 BOX  
THERMOSTAT BOX  
HEAT  
SENSOR  
WIRE  
CONNECTOR  
VENTILATOR  
MOTOR  
GREEN GROUND  
SCREW  
THERMOSTAT  
WIRE  
CONNECTOR  
WIRE  
CONNECTORS  
ATTIC  
LIVING AREA  
ON/OFF SWITCH  
120vAC, 60 Hz POWER,  
PLUG GROUND  
 

Milwaukee Impact Driver 9058 1 User Manual
MTD Tiller 217 310 000 User Manual
NAD Car Video System L 70 User Manual
NEC Telephone 2014 User Manual
NuTone Universal Remote ICA 441WH User Manual
Oki Printer 1220n User Manual
Olympus Camcorder D 340L User Manual
Panasonic Flat Panel Television CT 32SL32 User Manual
Panasonic Indoor Furnishings EP3513 User Manual
Panasonic Network Card MAZSxxx Series User Manual