Panasonic Telephone KXTGA630 User Manual

Installation Manual  
Additional Digital Cordless Handset  
Model No. KX-TGA630  
Thank you for purchasing a Panasonic digital cordless phone.  
This unit is an additional handset compatible with the following  
series of Panasonic Digital Cordless Phones:  
KX-TG6311/KX-TG6321/KX-TG9331/KX-TG9341/  
KX-TG9361/KX-TG9371  
You must register this handset with your base unit before it can  
be used. This installation manual describes only the steps  
needed to register and begin using the handset. Please read  
the base unit’s operating instructions for further details.  
Charge the batteries for about 7 hours before initial use.  
Please read this installation manual before using the unit and  
save it for future reference.  
For assistance, visit our website:  
for customers in the U.S.A. or  
Puerto Rico.  
PNQX1004ZA DM1207PF0  
 
Battery installation and battery charge  
Important:  
LUse the supplied rechargeable batteries (Part No. HHR-65AAABU).  
LWhen installing the batteries:  
– Wipe the battery ends (S, T) with a dry cloth.  
– Avoid touching the battery ends (S, T) or the unit contacts.  
– Ensure correct polarities (S, T).  
LWhen replacing the batteries:  
– USE ONLY rechargeable Ni-MH batteries AAA (R03) size.  
– Do NOT use Alkaline/Manganese/Ni-Cd batteries.  
– We recommend using the Panasonic rechargeable batteries noted  
in the base unit’s operating instructions for replacement battery  
information.  
1 Press the notch on the handset cover firmly, and slide it in the  
direction of the arrow.  
2 Insert the batteries negative (T) end first. Close the handset cover.  
3 Place the handset on the charger for about 7 hours before initial  
use.  
Note:  
LIf the batteries are fully charged, but the operating time seems to be  
shorter, clean the battery ends (S, T) and the charge contacts with a  
dry cloth.  
3
 
Attention:  
A nickel metal hydride battery that is  
recyclable powers the product you  
have purchased.  
Please call 1-800-8-BATTERY (1-  
800-822-8837) for information on how  
to recycle this battery.  
Registering a handset to a base unit  
1 Base unit:  
KX-TG6311/KX-TG9361  
Press and hold {LOCATOR} for 4 seconds. (No registration tone)  
KX-TG6321/KX-TG9331/KX-TG9341/KX-TG9371  
Press and hold {LOCATOR} for 4 seconds until the registration tone  
sounds.  
LIf all registered handsets start ringing, press the same button to  
stop. Then repeat this step.  
LThe next step should be completed within 90 seconds.  
2 Handset:  
Press {OK}, then wait until a long beep sounds.  
Note:  
LWhile registering, Base registeringis displayed on all  
registered handsets.  
LIf Error!!is displayed while registering, press {OFF} and register  
the handset again.  
Display language  
1 {MENU} i {#}{1}{1}{0}  
2 {V}/{^}: Select the desired setting.  
3 Press the right soft key to save. i {OFF}  
4
 
Wall mounting  
1 Drive the screws (not included) into the wall.  
2 Mount the charger (A), then slide it down (B) and to the right (C)  
until it is secure.  
25.4 mm  
A
(1 inch)  
B
C
Screws  
(120 V AC, 60 Hz)  
5
 
For your safety  
To prevent severe injury and loss of life/property, read this section  
carefully before using the product to ensure proper and safe operation of  
your product.  
WARNING  
Power connection  
LCompletely insert the AC adaptor/power plug into the power outlet.  
Failure to do so may cause electric shock and/or excessive heat  
resulting in a fire.  
LRegularly remove any dust, etc. from the AC adaptor/power plug by  
pulling it from the power outlet, then wiping with a dry cloth.  
Accumulated dust may cause an insulation defect from moisture, etc.  
resulting in a fire.  
LUnplug the product from power outlets if it emits smoke, an abnormal  
smell, or makes an unusual noise. These conditions can cause fire or  
electric shock. Confirm that smoke has stopped emitting and contact  
the Panasonic Call Center at 1-800-211- PANA (1-800-211-7262).  
Installation  
LTo prevent the risk of fire or electrical shock, do not expose the product  
to rain or any type of moisture.  
LDo not place or use this product near automatically controlled devices  
such as automatic doors and fire alarms. Radio waves emitted from  
this product may cause such devices to malfunction resulting in an  
accident.  
CAUTION  
Installation and relocation  
LThe AC adaptor is used as the main disconnect device. Ensure that  
the AC outlet is installed near the product and is easily accessible.  
6
 
Battery  
LWe recommend using the supplied batteries or additional/replacement  
batteries noted in the base unit’s operating instructions for  
replacement battery information. USE ONLY rechargeable Ni-MH  
batteries AAA (R03) size.  
LDo not mix old and new batteries.  
LDo not open or mutilate the batteries. Released electrolyte from the  
batteries is corrosive and may cause burns or injury to the eyes or skin.  
The electrolyte may be toxic if swallowed.  
LExercise care when handling the batteries. Do not allow conductive  
materials such as rings, bracelets or keys to touch the batteries,  
otherwise a short circuit may cause the batteries and/or the conductive  
material to overheat and cause burns.  
LCharge the batteries provided with or identified for use with this  
product only, in accordance with the instructions and limitations  
specified in this manual.  
LOnly use a compatible base unit (or charger) to charge the batteries.  
Do not tamper with the base unit (or charger). Failure to follow these  
instructions may cause the batteries to swell or explode.  
Other information  
LOperating the product near electrical appliances may cause  
interference. Move away from the electrical appliances.  
LUse only the power cord and batteries indicated in this manual. Do not  
dispose of batteries in a fire. They may explode. Check with local  
codes for possible special disposal instructions.  
Routine care  
LWipe the outer surface of the product with a soft moist cloth.  
LDo not use benzine, thinner, or any abrasive powder.  
Notice for product disposal, transfer, or return  
LThis product can store your private/confidential information. To protect  
your privacy/confidentiality, we recommend that you erase the  
7
 
information such as phonebook or caller list entries from the memory  
before you dispose of, transfer, or return the product.  
FCC and other information  
This equipment is hearing aid compatible as defined by the FCC in 47  
CFR Section 68.316.  
When you hold the phone to your ear, noise might be heard in your  
Hearing Aid. Some Hearing Aids are not adequately shielded from  
external RF (radio frequency) energy. If noise occurs, use the  
speakerphone option (if applicable) when using this phone. Consult with  
your audiologist or Hearing Aid manufacturer about the availability of  
Hearing Aids which provide adequate shielding to RF energy commonly  
emitted by digital devices.  
WHEN PROGRAMMING EMERGENCY NUMBERS AND(OR) MAKING  
TEST CALLS TO EMERGENCY NUMBERS:  
1) Remain on the line and briefly explain to the dispatcher the reason for  
the call.  
2) Perform such activities in the off-peak hours, such as early morning or  
late evenings.  
This device complies with Part 15 of the FCC Rules. Operation is subject  
to the following two conditions:  
(1) This device may not cause harmful interference, and (2) this device  
must accept any interference received, including interference that may  
cause undesired operation.  
Privacy of communications may not be ensured when using this phone.  
CAUTION:  
Any changes or modifications not expressly approved by the party  
responsible for compliance could void the user’s authority to operate this  
device.  
8
 
NOTE:  
This equipment has been tested and found to comply with the limits for  
a Class B digital device, pursuant to Part 15 of the FCC Rules. These  
limits are designed to provide reasonable protection against harmful  
interference in a residential installation. This equipment generates, uses,  
and can radiate radio frequency energy and, if not installed and used in  
accordance with the instructions, may cause harmful interference to  
radio communications. However, there is no guarantee that interference  
will not occur in a particular installation. If this equipment does cause  
harmful interference to radio or television reception, which can be  
determined by turning the equipment off and on, the user is encouraged  
to try to correct the interference by one or more of the following  
measures:  
– Reorient or relocate the receiving antenna.  
– Increase the separation between the equipment and receiver.  
– Connect the equipment into an outlet on a circuit different from that to  
which the receiver is connected.  
– Consult the dealer or an experienced radio/TV technician for help.  
FCC RF Exposure Warning:  
LThis product complies with FCC radiation exposure limits set forth for  
an uncontrolled environment.  
LThis handset may not be collocated or operated in conjunction with  
any other antenna or transmitter.  
LFor body-worn operation, the handset must be used only with a non-  
metallic accessory. Use of other accessories may not ensure  
compliance with FCC RF exposure requirements.  
Notice  
LFCC ID can be found inside the battery compartment or on the bottom  
of the unit.  
9
 
Notice  
LThis product is designed for use in the United States of America.  
Sale or use of this product in other countries may violate local laws.  
LCet appareil est conçu pour être utilisé aux États-Unis d’Amérique.  
La vente ou l’emploi de cet appareil dans certains autres pays peut  
constituer une infraction à la législation locale.  
LEste producto está diseñado para usarse en los Estados Unidos de  
América.  
La venta o el empleo de este producto en ciertos países puede  
constituir violación de la legislación local.  
Lҏ౰ࠢட
छ୽
ٺ
ҢՄ೩Ȅषӵ
ڏ
т୽ড়᎛୵
ٺܖ
ҢȂџ૖ོႂІ࿋  
Ӵ
ٽݲ
Ȅ  
L
ߩߎ
⵾ຠ
ޔߪ
ᣣᧄ࿖ᄖ
ߩߢ
૶↪
⋡⊛
ߡߒߣ
⸳⸘
ޔࠅ߅ߡࠇߐ
ᣣᧄ  
࿖ౝ
ߩߢ
૶↪
ߪ
ᴺᓞ㆑෻
ࠅߥߣ
߹
ޕߔ
ޔߡߞ
ᒰ␠
ߪߢ
ᣣᧄ࿖ౝ
ߦ
 
߅
ߪߡ޿
ේೣ
ߡߒߣ
ୃℂ
ࡆ࡯ࠨߩߤߥ
ߪ
ߨ߆ߒ
߹
ޕߔ
 
 
If you need assistance with setup or  
operation  
3 Call us at: 1-800-211-PANA (1-800-211-7262)  
TTY users (hearing or speech impaired users) can call 1-877-833-  
8855.  
When you ship the product  
LCarefully pack your unit, preferably in the original carton.  
LAttach a letter, detailing the symptom.  
LSend the unit to PSTC (Panasonic) Exchange Center, prepaid and  
adequately insured.  
LDo not send your unit to Panasonic Consumer Electronics Company  
listed below or to executive or regional sales offices. These locations  
do not repair consumer products.  
Panasonic Consumer Electronics Company,  
Division of Panasonic Corporation of North America  
One Panasonic Way, Secaucus, New Jersey 07094  
Panasonic Puerto Rico, Inc.  
San Gabriel Industrial Park, Ave. 65 de Infantería, Km. 9.5, Carolina,  
Puerto Rico 00985  
Copyright:  
This material is copyrighted by Panasonic Communications Co., Ltd.,  
and may be reproduced for internal use only. All other reproduction, in  
whole or in part, is prohibited without the written consent of Panasonic  
Communications Co., Ltd.  
© 2007 Panasonic Communications Co., Ltd. All Rights Reserved.  
 

Miller Electric Welding System TM 499C User Manual
Musical Fidelity CD Player M3CD User Manual
Napoleon Fireplaces Water Heater GVFS20N User Manual
Nilfisk ALTO Pressure Washer C 1102 X TRA User Manual
Nokia Satellite TV System 110T User Manual
NuTone Ventilation Hood QTXN110HFLT User Manual
Panasonic Car Stereo System CQ C1505W User Manual
Panasonic Cell Phone EB GD95 User Manual
Panasonic Flat Panel Television GPH5D User Manual
ParaBody Home Gym 835102 User Manual