Panasonic Digital Camera BB HCE481 User Manual

Installation Guide  
Network Camera  
Please read the Important Information before using.  
"Network Camera" is called "Camera" in this manual.  
"Setup CD-ROM" is called "CD-ROM" in this manual.  
The illustrations used in this manual are of BB-HCM381.  
Indoor Use Only  
Model No. BB-HCM381 (AC Adaptor Type)  
BB-HCE481 (PoE Type)  
This manual is for both BB-HCM381 (AC Adaptor Type) and BB-HCE481 (PoE Type). Available features and operations  
are different in part depending on the model. Read the Operating Instructions on the CD-ROM carefully and use the  
Network Camera properly.  
Mount the camera after the camera is connected and finished setting up following Getting Started.  
Installation Procedures  
Temporarily place  
Temporarily place the camera where you like to view images.  
the camera.  
Adjust the position and direction of the camera while you confirm that  
images are displayed on the monitor as you imaged.  
Adjust the position and  
direction of the camera.  
The camera can be mounted on the ceiling.  
Attach the camera firmly when mounting on the ceiling.  
Attach the camera.  
The camera can be viewed in the least light requirement at 3 lx (default). Use supplemental lighting for the dimly lit places.  
(The camera can be viewed in the least of 0.09 lx in the color night view mode (see page 86 of the Operating Instructions on  
the CD-ROM), which may increase the refresh interval.)  
After preparing the Ethernet cable that has enough length, mount the camera.  
Mounting and cabling instructions described in this Installation Guide follow generally accepted guidelines suitable for residential  
installations. In some areas, commercial and industrial installations are regulated by local or state ordinances. For such installations,  
contact your local building department or building inspector for more details.  
Wiring through a hole made in the ceiling  
Mounting on the Ceiling  
Make sure the camera is firmly mounted on the ceiling.  
Attach the Ceiling Plate B on the ceiling with Screws B.  
1
The camera is available between 15˚ based on level line  
for mounting.  
Keep more than 100 mm  
off the wall or other obstacles.  
The camera should be uninstalled from the ceiling when removing  
the SD memory card (see page 146 of the Operating Instructions  
on the CD-ROM).  
Camera direction  
The camera is intended for indoor use only. Prolonged exposure  
to direct sunlight or halogen light may damage CCD.  
100 mm  
The camera's MAC address and serial number are printed on the  
bottom of the camera. They are needed in order for camera  
configuration and maintenance. Record both of them for before  
mounting the camera.  
Set the Mounting type setting to [On the ceiling] on the Camera Setup  
page (see page 86 of the Operating Instructions on the CD-ROM).  
Screws B (4 pcs.)  
Two ways of wiring can be considered; wiring through a hole made  
in the ceiling or wiring without making a hole for a cable in the ceiling.  
Select either one of the two.  
Attach the Ceiling Plate B more than 100 mm off the wall or other  
obstacles from its center.  
Make sure the camera is firmly mounted on a beam of wood etc.  
When there is no beam, apply a board on the other side of the  
ceiling to make sure the camera does not drop.  
The audio cable or audio/video cable cannot be connected or  
removed after mounting on the ceiling.  
©
2006 Panasonic Communications Co., Ltd. All Rights Reserved.  
KK0306JT0 (CE)  
PQQX15195ZA  
 

Miele Clothes Dryer 09 696 880 User Manual
Miele Cooktop KM6322 User Manual
Multi Tech Systems Network Card 40 01459 D0 001 User Manual
NEC Calculator NDA 30103 004 User Manual
NETGEAR Network Router ac5300 User Manual
NETGEAR Switch GSM7248R User Manual
Oricom Cordless Telephone TA2000 Series User Manual
Panasonic Laptop Docking Station 71700140 User Manual
Panasonic Security Camera GP MF130 User Manual
Parasound CD Player C DP 2000 User Manual