FLEXware16 Amp Maximum 30VDC/250VAC
Rated Relay and DIN Mount Base with LED
RELAY
BASE
LED
FRONT VIEW
SIDE VIEW
The FLEXware Relay Assembly will activate a two-wire start generator
when wired to the AUX output of either an OutBack FX Inverter/Charger
or an OutBack Charge Controller. The assembly consists of an LED
module and a relay inserted (in one orientation) into a base. The base is
mounted onto the DIN rail of any OutBack AC industrial control panel.
Relay Features:
•
•
•
•
•
Rated current - 16 amps AC/DC 8 amps per terminal
Rated voltage - 30VDC/250VAC
Coil power draw - 400 mW
Gold contacts for use in low power situations
A green LED lights to show the relay energizing when proper
voltage is applied to the relay coil connectors.
•
Base accommodates connections for wiring the coil, common relay
contacts, normally open relay contacts, and normally closed relay
contacts.
TWO WIRE START
GENERATOR
HOOK UP
GENERATOR
FX INVERTER/CHARGER
INVERTER
ON/OFF
AUX +
12V RELAY
AUX -
XCT -
XCT +
There are two screw terminals for each relay contact. Each
can handle up to 8 amps. They are tied together internally.
COM 11 and COM 21 are the common relay connections.
Either can be used for loads under 8 amps. If the load
exceeds 8 amps, use both COM 11 and COM 21.
rꢀꢀ NO 14 and NO 24 are normally open relay connections.
Use both 14 and 24 terminals for loads exceeding 8 amps.
rꢀ NC 12 and NC 22 are normally closed relay connections.
Use both 12 and 22 terminals for more than 8 amps.
NOTE: If a load exceeds 8 amps, use both screw terminals for any
given relay contact to distribute the current and avoid overloading
the screw terminal.
Terminal screw torque – 0.5 Nm (4.4 inch lbs)
Corporate Office
European Sales Office
C/ Castelló, 17
08830 - Sant Boi de Llobregat
BARCELONA, España
19009 62nd Avenue NE
Arlington, WA USA
(+1) 360-435-6030
Phone: +34.93.654.9568
900-0018-01-00 REV A
|