QUICK START GUIDE SET-UP WIRELESS SENSOR
B
OREGON SCIENTIFIC WEATHER COLLECTION
4
3
You will have one of the following Oregon Scientific products:
100 : EMR201A
400 : BAR206A
1
2
200 : RMR202A
500 : BAR208HGA
: RMR203HGA
RAIN AND TEMPERATURE STATION:
300
RGR202A
3
4
Assign a channel by sliding selection switch to the appropriate
channel (1,2,3) location. If installing additional sensors, make
sure you assign a different channel for each sensor.
UNPACK
A
Make sure that you have all of the parts of one of the three
groups of products shown here before the installation of your
Weather Collection product.
Press the reset button
1
2
Slide open battery door
Install the battery, matching polarity (+/-)
*Before placing the sensor outdoors, please verify
communication with the main unit by placing the sensor next to
the base unit during this setup process.
WEATHER
WEATHER 500
100-400
SET-UP MAIN UNIT
C
Main Unit
THN132N
Temperature
Sensor
Main Unit
THGR122NR
Temperature/
Humidity Sensor
1×
1×
1×
1×
1
2
Time is synchronized.
Receiving signal is strong.
3
RAIN AND
TEMPERATURE STATION
Time is not synchronized.
Receiving signal is weak.
3
Atomic Clock Signal
Atomic clock synchronization will automatically occur after
installing the batteries. Reception takes 2-10 minutes. If the
signal is weak, it can take up to 24 hours to retrieve a valid
signal.
Rain Collector
Filter
1×
1×
6×
2
There are two types of signals the main unit will receive:
Temperature Signal
1
Install the required number of batteries in the battery
compartment located on the back of each main unit.
After installing the batteries, the main unit will automatically
search for the signal from the wireless sensor. Once a
temperature reading is displayed on the LCD screen,
communication is now established.
*Please monitor atomic clock icon ( ) on the bottom part of the
LCD display next to the time. This icon indicates the status of
the clock reception signal.
Main Unit
THN132N
Temperature
Sensor
1×
1×
Screws (Type C)
Washers
3×
|