®
S I M P L Y
A M A Z I N G
USER’S GUIDE
COMPACT
CANISTER
VACUUMS
BBB1005
•IMPORTANT•
SAVE THIS BOOKLET!
Includes:
• Safety Warnings
• Parts List
• Operating Instructions
• Maintenance
• Warranty
• Trouble Diagnosis
• Accessories List
The fuse carrier is red and hinged to the plug. Do not use the plug
if it is different.
BEFORE OPERATING
CLEANER, READ ALL
INSTRUCTIONS IN THIS
MANUAL CAREFULLY.
If necessary, you may contact customer service for replacement
fuse covers.
MOTOR PROTECTION SYSTEM: If fine materials such as soot,
cement, plaster dust, copy machine powder, etc. are picked up,
the bag surface may seal and cause the motor to shut off to
avoid over-heating. If this happens, turn the switch off then turn
off the wall socket and/or unplug the cleaner. Replace filter bag.
Check and clear any clogs in hose or accessories. After
approximately 30 min. the motor will have cooled and the cleaner
will be ready to use.
Table of Contents
Note: The cleaner must remain unplugged for 30 minutes
for motor to cool and system to reset.
Safeguards, Important Electrical Information,
Important Safety Instructions . . . . . . . . . . . . . . . . . . . . page 5-2
Warranty, Parts List, Accessories . . . . . . . . . . . . . . . . . page 5-3
IMPORTANT
Assembly, Polarized Plug Notice, To Operate,
Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 5-4
SAFETY INSTRUCTIONS
When using an electrical appliance, basic
precautions should always be followed,
including the following:
Maintenance & Customer Service,
Troubleshooting Guide . . . . . . . . . . . . . . . . . . . . . . . . . page 5-5
READ ALL INSTRUCTIONS BEFORE
USING THIS VACUUM CLEANER
Safeguards
WARNING
WARNING: Unplug cord from electrical
outlet before servicing.
To reduce the risk of fire,
electric shock, or injury:
• IMPORTANT: Make sure filter bag is in place. Do not operate
cleaner without filter bag. Damage to motor may occur.
• Do not leave appliance unattended when plugged in.
Unplug from outlet when not in use and before servicing.
• Be sure bag gasket is in place. If the white bag gasket is
damaged or lost, replace at once.
• Do not use outdoors or on wet surfaces.
• Do not allow to be used as a toy. Close attention is
necessary when used by or near children.
• For best results, change disposable filter bag regularly even if
it is not completely full. An extremely dirty bag or a bag close
to full will affect the suction of the cleaner and can create
excessive motor heat that could damage the motor. A good
practice is to change filter bag every 30 days even if it is not full.
• Use only as described in this manual.
• Do not use with damaged cord or plug. If appliance is not
working as it should, has been dropped, damaged, left
outdoors, or dropped into water, return it to a service
center or call customer service at: 0845 603 0153.
• Do not pick up moist material or liquids.
• Clean your vacuum cleaner with a damp (not wet) cloth in the
disposable bag cavity and the outside of canister unit.
• Do not pull or carry by cord, use cord as a handle, close
door on cord, or pull cord around sharp edges or corners.
Do not run appliance over cord. Keep cord away from
heated surfaces.
• IMPORTANT: DO NOT REMOVE the dirt retaining flap
attached on the back of the front plate. It must be left in place
for the unit to operate properly and to ensure cleaning
effectiveness.
• Do not unplug by pulling on cord. To unplug, grasp the
plug, not the cord.
• Do not handle plug or appliance with wet hands.
• Do not put any object into openings. Do not use with any
opening blocked; keep free of dust, lint, hair and anything
else that may reduce air flow.
Important Electrical Information
The wires in the main lead are coloured in accordance with the following
code:
• Keep hair, loose clothing, fingers and all parts of body
away from openings and moving parts.
Blue - Neutral
Brown - Live
• Do not use to pick up anything that is burning or smoking,
such as cigarettes, matches, or hot ashes.
If the colours of the wires in the main lead of this appliance do not
correspond with the coloured markings identifying the terminals in your
plug, proceed as follows:
• Do not use without filter bag assembly in place.
• Turn off all controls before unplugging.
• Use extra care when cleaning on stairs.
The wire which is coloured blue must be connected to the terminal
marked with the letter N or coloured black. The wire coloured brown
must be connected to the terminal marked with the letter L or coloured
red. Do not make any connection to the terminal marked E or or
coloured green and yellow.
• Do not use to pick up flammable or combustible
liquids, such as gasoline, or use in areas where they may
be present.
This appliance is double insulated and no earth connection is necessary.
If you remove the plug from power supply cord, dispose of it. A
shock hazard could result if incorrect plug is inserted into a 13
AMP socket outlet.
SAVE THESE INSTRUCTIONS
When changing fuse, use 5 AMP or same size replacement
fuse.
Household Use Only
2
Never use the plug without the fuse cover fitted in place.
Warranty
Parts List
ORECK MANUFACTURING COMPANY: (Oreck Manufacturing Company,
21180 Johnson Road; Long Beach, MS, USA 39560, gives you the
following limited warranty for this product only if it was originally purchased
for residential use, not resale from Oreck or an Oreck Authorized Retail
Dealer.)
1
Oreck will repair or replace, free of charge, to the original purchaser, any
part that is found to be defective in material or workmanship within three
(3) years of the date of purchase; ten (10) years on housing. This limited
warranty applies to normal domestic use. Any commercial use of this
product will void this limited warranty.
6
This limited warranty does not cover the replacement of expendable or
consumable parts such as belts, brushes, bulbs, disposable bags and
other parts subject to normal wear unless they are defective in material or
workmanship.
4
8
This limited warranty does not apply to any part subjected to accident,
abuse, commercial use, alteration, misuse, damage caused by act of God,
the use of voltages other than indicated on the serial number displayed on
this product or service of this product by other than Oreck or a
participating Factory Authorized Service Center.
2
3
10
Oreck does not authorize any person or representative to assume or grant
any other warranty obligation with the sale of this product.
5
7
Oreck’s limited warranty is valid only if you retain proof of purchase from
Oreck or an Oreck Authorized Retail Dealer for this product. If you
purchase this product from any other source, your purchase is “AS IS,”
which means Oreck grants you no warranty, and that you, not Oreck,
assume the entire risk of the quality and performance of this product,
including the entire cost of any necessary servicing or repairs of any
defects.
9
1. Adjustable shoulder strap
2. Long, extendable, flexible hose
3. Crevice tool
This warranty in addition to your statutory and other legal rights.
4. Upholstery tool
5. Horsehair bare floor and wall tool
6. Horsehair dusting brush
7. Adjustable extension wand
8. On-board tool caddy
9. Paper filter bags
*Reconditioned units carry a 6 month warranty from date of
purchase.
10. Tool adapter tube for fitting tools directly to vacuum when
not using hose.
G
HEPA filter (not shown)
G
Scent cartridge (not shown)
Accessories (Sold Separately)
Replacement Hypo-Allergenic Filter
Bags (12 pk. with 1 Micro Filter)
Replacement Micro Filter
Replacement HEPA Filter
Part No. PKBB12DW
Part No. 72005-01
Part No. HF1000
Replacement White Bag
Gasket
Part No. 72017-02
Wheel Kit
Part No. 09-73069-01
Part No. CADDYBB
Vinyl Tool Rack
Fresh Air® Scent Cartridges
Notes of Vanilla® 8pk.
Part No. FA1PK
Part No. FA2PK
Part No. FA3PK
Spring Mullberries® 8pk.
Blooming Jasmine® 8pk.
To order new parts or accessories call:
0845 603 0153
3
For Easy Cord Storage
Assembly
fig. 12 Wrap cord around the cord wrap and cord dump located
on bottom of the canister. To release cord, twist the cord
dump.
IMPORTANT: DO NOT
REMOVE the dirt
retaining flap
Blower Port
attached on the
back of the front
plate. It must be left
in place for the unit
to operate properly
and to ensure
fig. 13 Remove HEPA Filter cover and filter at back of machine.
Firmly insert flexible hose into blower port.
Maintenance
WARNING: Unplug cord from electrical
outlet before servicing.
cleaning
effectiveness.
Changing the Filter Bag
Attach Caddy and Insert Tools
fig. 14
Use only genuine ORECK XL filter bags. Stand unit on
its back. Twist knob counterclockwise to release and
lift out front plate.
fig. 1 Locate caddy clip slots at top rear corners of canister
handle. Place appliance on firm, non-slip surface or hold
in your lap. Grasp handle firmly. Place one of caddy clip
tabs inside slot on one side of handle and stretch the
other tab around handle until the opposite tab inserts in
slot.
fig. 15 Remove used bag and insert fresh bag. The cardboard
rim fits smoothly into the recessed top. Align tabs on
front plate with slots in housing and replace the front
plate. Close unit by turning knob clockwise.
fig. 2 Insert crevice tool, brush and fabric tool into caddy in
fig. 16 IMPORTANT: The white bag gasket glued in the housing
must be in place or unit will not operate properly.
Replace if needed.
spaces provided.
fig. 3 Caddy will lift up 90° to allow access to the HEPA filter
cover.
NOTE: The disposable inner filter bag must be replaced once a
month even if it is not full. Change it more often if it is
used in extremely dirty areas. Increase the cleaning
power of your vacuum by changing the bag often.
Attach Shoulder Strap
fig. 4 Clamp one end of shoulder strap in front slot located at
front of handle.
Replacing the Micro Filter
fig. 5 Clamp opposite end of shoulder strap in slot at back of
handle.
Remove filter bag by following the Changing the Filter Bag
instructions.
fig. 6 Adjust length by pulling strap through clip.
fig. 17 Remove old micro filter from bottom inside unit. Replace
IMPORTANT: Before using shoulder strap, pull both ends to be
sure it is secure.
with new filter.
NOTE: A replacement filter is supplied in each package of 12
ORECK XL filter bags or you may order filters separately.
To Operate
Using a HEPA-Filter and Scent Cartridge
fig. 18 Remove HEPA Filter cover at back of machine by
pressing down in top slot and folding back the cover. Lift
cover to remove.
Plug cord into electrical outlet.
Power Switch
fig. 19 Insert Fresh Air® Scent Cartridge on tab located in center
fig. 7 Push power switch to “ON” (I) position.
of the filter cover.
Hose and Tool Installation
fig. 20 Place the HEPA Filter in the filter cover.
fig. 8 The flexible hose uses a Shurlock® locking system that
prevents hose removal unless intended. To install hose,
align “J” slot in hose coupling with tab inside the suction
port. Insert hose into suction port. Twist collar clockwise
to lock hose coupling in port. Twist counterclockwise and
pull to remove hose.
fig. 18 Replace the HEPA Filter assembly on the canister by
placing the bottom lip of the cover in the inside slot of
the canister and closing the cover until the top latch is
locked.
NOTE: It is recommended to replace the scent cartridge when
fig. 9 The adjustable extension wand and cleaning tools
supplied with your Oreck XL Compact Canister Vacuum
lock together with friction. Twist and push to be sure they
lock tightly when installing. Twist and pull to remove.
the inner filter bag is replaced.
Replace the HEPA filter every 6 months. Replace more
often if vacuum is used to pick up fine particles or in
extremely dirty areas.
fig.10 When installing tools directly to blower or suction port
without using hose, tool adapter tube must be used.
Adjustable Extension Wand
fig. 11 To adjust extension wand, press release button and pull
inner tube to desired length. Tube will lock when button
is released. To shorten length, press release button and
push inner tube.
4
Maintenance and Customer Service
Your ORECK COMPACT CANISTER VACUUM is a product of
precise engineering. The motor bearings are permanently
lubricated and should not be oiled. If you require additional
information or have problems with your ORECK appliance, you
may call ORECK customer service or write to:
Telephone: 0845 603 0153
Oreck UK
P.O. Box 107
Exeter
EX2 8ZQ
Attention: Oreck Customer Service
Please specify the model number and serial/code number which
can be found on the data plate on the bottom of the vacuum.
Save your sales or purchase slip. Should your ORECK
appliance require warranty service in the U.S.A., present this slip
to the Authorized Service Center as your proof of purchase date,
or, in Canada, call customer service.
Troubleshooting Guide
PROBLEM
POSSIBLE SOURCE
AREAS TO CHECK
Cleaner Will
Not Run
1.Not plugged in
properly
1.Be sure cleaner is
firmly plugged into
wall outlet.
2.No electricity in
wall outlet.
2.Check electrical
source–fuse or
circuit breaker.
3.Motor protector
tripped.
3.See Motor
Protection System
page 2.
4.Needs service.
4.Take to service
center or call for
nearest service
center.
Vacuum Will
Not Pick Up
Or Has Low
Suction
1.Filter bag is full.
1.Replace filter bag.
See “Changing
the Filter Bag,”
page 4.
2.Hose/wand tool
is clogged.
2.Remove
obstructions.
3.Air leak due to
missing or
damaged gasket.
3.Replace gasket
See page 4.
1.Proper friction fit
not being
obtained.
Tools/Wands
Will Not Stay
Together
1.Push and turn.
ALL OTHER SERVICING SHOULD BE DONE BY AN
ORECK AUTHORIZED SERVICE CENTER.
CALL CUSTOMER SERVICE HOT LINE
0845 603 0153
Whenever calling, please be sure to have your model and serial
number from data plate.
5
6
73063-01 REV B 06/05 ECN# R-8022
©2005 Oreck Holdings, LLC. All rights reserved. All word marks, logos, product configurations, and registered trademarks are owned and used under the
authority of Oreck Holdings, LLC.
|