Oreck Air Cleaner AIR7 User Manual

®
S I M P L Y  
A M A Z I N G  
USERS GUIDE  
Table Top Air Purifier  
AIR7  
Series  
•IMPORTANT•  
SAVE THIS BOOKLET!  
Includes:  
• Warranty  
• Safety Warnings  
• Parts List  
• Operating Instructions  
• Accessories List  
• Trouble Diagnosis  
 
2
5
3
6
1
4
7
Operation  
5
1
How Your Electronic Air Purifier Works  
4
2
Polluted air enters the air purifier through the front grill. As the air is  
pulled through, a pre-filter helps trap large particles (hair, lint, etc.). Then  
an electronic ionizer electrostatically charges smaller particles (dust,  
smoke, pollen). The positive charged particles then enter the negatively  
charged electronic cell, where the aluminum plates attract and retain the  
particles. It works like a powerful magnet and the particles remain until  
the electronic cell is cleaned. The air then passes through a charcoal  
odor absorber that helps remove household odors. Next, the negative  
ion generator releases negative ions to freshen the air. Finally,  
3
1. MAIN POWER SWITCH: Turn the unit on by sliding the power switch  
to the blower speed you prefer: High ( ) for maximum cleaning -  
Medium ( ) for normal use - Low ( ) for quiet operation.  
electronically cleaned air passes back into the room through the top grill.  
2. FRAGRANCE CARTRIDGE: Fragrance compartment switch ejects  
drawer for access to fragrance cartridge. Insert fragrance cartridge  
and close drawer. One fragrance cartridge included.  
3. IONIZER POWER SWITCH: Turns the ionizer ON or OFF. The  
indicator light will glow green when ON and functioning properly.  
4. POWER INDICATOR LIGHT: The indicator light will glow green when  
the unit is operating normally. It will flash red when the collector cell  
requires cleaning. NOTE: The light will glow red for a moment  
when unit is first turned on. This is normal and only a test of the  
system.  
5. AIR DIRECTION CONTROL: Slide switch on top of unit controls the  
louvers and enables you to direct airflow to desired areas.  
NOTE: You may notice an occasional infrequent sharp snapping  
sound coming from your unit. This is a normal occurrence called  
“arcing” and results as large particles of dust are collected in the  
ionizing-collecting cell. Should prolonged or continuous arcing  
occur, the ionizing-collecting cell should be thoroughly cleaned  
and dried completely (See “Cleaning Collector Cell”).  
PRE-FILTER  
ELECTRONIC CELL  
CHARCOAL ODOR POWERFUL FAN  
ABSORBER  
Instructions  
WARNING: DO NOT USE THIS ELECTRONIC AIR PURIFIER WHEN  
OXYGEN TANKS ARE BEING USED OR IN THE PRESENCE OF  
COMBUSTIBLE GASES.  
ELECTRONIC IONIZER  
NEGATIVE ION GENERATOR  
3
 
IMPORTANT NOTES:  
every two months or as needed. IMPORTANT: DO NOT wash the  
charcoal odor absorber. Replace, if necessary.  
G
Your air purifier works best if you leave it in operation all the time.  
G
Replacing Cell After Cleaning  
1. Snap in the charcoal odor absorber. (fig. 3)  
2. Slide in the pre-filter. (fig. 4)  
3. Slide cell into cabinet, using handles. (fig. 2)  
4. Replace front grill. Unit is now ready for operation. (fig. 1)  
NOTE: An occasional “arcing” sound is normal when operating the  
unit immediately after cleaning the cell and should stop after a few  
minutes of operation.  
Place or mount the air purifier near a standard electrical outlet. Do  
not block either the air intake or outlet grill.  
G
Never place your air purifier on soft surfaces (such as bed, sofas or  
carpet), near computers or next to sources of heat (such as stove  
tops, ovens, etc.)  
G
Make sure the front grill is securely locked in place.  
G
A safety switch is installed behind the grill of your electronic air  
purifier. If the grill is not properly secured in place, the unit will not  
operate. If your unit fails to operate, remove the front grill and reinstall  
it, being sure that the lower right-hand side of the grill (next to the  
control panel) is firmly locked in place.  
Replacing Fragrance Cartridge  
1. Open cartridge compartment by sliding the compartment release switch.  
(fig. 5)  
G
Plug the power cord into the nearest available standard electrical  
outlet. (See data label on bottom of your air purifier for electrical  
specifications and power consumption.)  
2. Remove fragrance disk from center of cartridge and replace with a  
new one. (fig. 6)  
G
Do not use an extension cord to supply power to your air purifier.  
3. Close compartment until it locks. (fig. 7)  
NOTE: One fragrance cartridge is included.  
Cleaning  
Troubleshooting Guide  
The Cabinet  
Service problems that appear to be major can often be solved easily. You  
can be your own troubleshooter by reviewing the chart below. It pinpoints  
problems and how to correct them. Remember, check the simple things first.  
You can clean the air purifier cabinet with mild, non-abrasive cleanser and a  
soft cloth. IMPORTANT: Unplug the unit from its electrical power source.  
Do not spray cleansers or furniture polish into the louver or grill areas.  
PROBLEM  
UNIT DOES NOT TURN  
CHECK  
1. Power Cord  
WHAT TO DO  
1. Plug in power cord  
Collector Cell  
Indicator light is green under normal operation and flashes red  
when the cell requires cleaning. To clean, proceed as follows:  
ON  
2. Selector Switch  
2. Set selector switch  
for desired blower  
speed.  
The red "WASH CELL" light will flash or illuminate when it is  
time to clean your cell. However, it is recommended that every four to  
eight weeks or if snapping sounds become frequent, clean your  
electronic air purifier. Your electronic air purifier is still filtering the air  
when the red light illuminates. Cleaning your electronic air purifier is a  
snap too... and a must for efficient operation.  
3. Reinsert front grill  
until it is flush with  
cabinet front. Tap grill  
lightly, if necessary, to  
fully insert.  
3. Front Grill  
1. Turn the unit off and unplug it from the electric power source. If wall  
mounted, remove unit from wall.  
Wash ionizer/collector  
cell. Make sure it is  
thoroughly clean & dry  
before re-installing it.  
INDICATOR LIGHT ON  
UNIT IS FLASHING RED  
OR HAS TURNED RED  
Ionizer/collector cell  
2. Remove front grill by unscrewing the retainer screw under the grill on  
the cabinet bottom. (fig. 1)  
3. Pull the cell out of the cabinet by using the two small handles on the  
front of the cell. (fig. 2)  
UNIT DOES NOT  
Wash cell  
Ionizer/collector cell  
Ionizer/collector cell  
REMOVE POLLUTANTS  
UNIT SPARKS,  
A little is normal. Make  
sure the cell is  
thoroughly dry before  
re-installing it.  
4. Snap off the charcoal odor absorber from the back of the cell. Change  
as necessary for continued odor removal. (fig. 3)  
CRACKLES AND POPS  
5. Slide off pre-filter. This can be cleaned with the cell and reused. (fig. 4)  
NOTE: Handle the electronic cell with care. Damaged metal plates  
and/or broken wires will cause the air purifier to malfunction. (Do  
not wash charcoal odor absorber; it is disposable.)  
Cleaning with Assail-A-Cell® Cell Cleaner:  
6. Using Assail-A-Cell® Cleaner, thoroughly saturate the cell and pre-  
filter. Be sure to spray between each cell plate and cover every  
surface. Allow product to soak for a few minutes, not allowing it to dry.  
Rinse thoroughly with water. For extremely heavy deposits, repeat the  
process.  
If it persists, clean cell.  
If that doesn’t help, cell  
may be damaged and  
needs replacing.  
DOES NOT REMOVE  
ODOR  
Old Charcoal Odor  
Absorber  
Check all the above  
points  
Replace Charcoal  
Odor Absorber.  
UNIT STILL DOES NOT  
OPERATE PROPERLY  
Return unit to the  
Service Center.  
ALL OTHER SERVICING SHOULD BE DONE BY AN  
ORECK AUTHORIZED SERVICE CENTER.  
IMPORTANT: Dry the collection cell thoroughly outside of the  
air purifier before reinstalling it into the air purifier. Ensure  
that all areas including corners and areas that may trap  
water are dry before reinstalling into the air purifier. DO NOT  
place a wet or damp collection cell in the air purifier.  
CALL CUSTOMER SERVICE HOT LINE  
US:1-800-989-3535 Canada: 1-888-676-7325  
Whenever calling, please be sure to have your model and serial  
number from data plate.  
Replacing the Charcoal Odor  
Absorber (Optional)  
Accessories  
In addition to air purification, your Oreck provides the additional benefit  
of odor removal. The odor removal function is optional. Your Oreck Air  
Purifier will continue to remove harmful airborne particles with its  
permanent electronic collector cell even if you choose not to use the  
optional charcoal odor absorber.  
ITEM  
1.  
2.  
3.  
4.  
PART #  
Pre-Filter  
7780-8041  
09-5510-7065  
AT4PK7  
Ionizer/Collector Cell  
Charcoal Odor Absorber (Set of 4)  
Wall Mounting Kit  
8660-0201  
Odor absorption effectiveness will gradually deteriorate over time unless  
the charcoal odor absorber is replaced. While every environment is  
different, Oreck suggests that the charcoal odor absorber be replaced  
5.  
Oreck Fresh Air® Scent Cartridges  
Spring Mulberries®, 8pk.  
FA2PK  
FA3PK  
Blooming Jasmine®, 8pk.  
© 2006 Oreck Holdings, LLC. All Rights Reserved. All word mark, logos, product configurations, and registered trademarks are  
owned and used under the authority of Oreck Holdings, LLC. 3323-3018 REV H 01/06 ECN# R-8239, R-8240  
 
4

Nady Systems Microphone SCM 900 User Manual
Nady Systems Microphone UHF3HT48055 User Manual
Network Technologies Switch 17 N PRIMUX User Manual
Olympus Camcorder C 575 User Manual
Onkyo Cassette Player 144 User Manual
Onkyo Stereo System PA MC5500 User Manual
Oregon Scientific Clock Radio RRA320P User Manual
Panasonic Camera Accessories GP US522CU User Manual
Panasonic Cordless Telephone KX TG1032 User Manual
Patton electronic Surge Protector 503S User Manual