Onkyo Headphones HTP 938 User Manual

E
n
5.1ch Home Theater Speaker Package  
HTP-938  
Front speakers (SKF-980)  
Surround speakers (SKR-980)  
Center speaker (SKC-980)  
Powered subwoofer (SKW-938)  
RCA cable 3.0 m  
(Green)  
Speaker cable 3.0 m  
(White)  
(Red)  
(Blue)  
Speaker cables 8.0 m  
(Gray)  
Center speaker*1  
Surround speakers*2  
Speaker cables 3.5 m  
Subwoofer*2  
Front speakers*1  
*2  
Non-magnetic shielding.  
Front  
*1  
*2  
For magnetic shielding.  
Non-magnetic shielding.  
Standby/On indicator  
Red: Subwoofer in standby mode  
Blue: Subwoofer on  
Cork spacer (12 pcs.) for front and  
center speakers  
With the Auto Standby function, the  
SKW-938 automatically turns on when  
an input signal is detected in Standby  
mode. When there’s no input signal for  
a while, the SKW-938 automatically  
enters Standby mode.  
Speakerterminals  
Keyhole slot  
Keyhole slot  
Rear  
Speaker  
terminals  
SKC-980  
POWER switch  
Speaker  
terminals  
Press this switch to the ON position to  
turn on the power. Press it to the OFF  
position to turn off the power.  
SKR-980  
Keyhole slots  
SKF-980  
OUTPUT LEVEL control  
This control is used to adjust the vol-  
ume of the subwoofer.  
Wall Mounting  
LINE INPUT  
To AC outlet  
To mount the front/surround speakers vertically, use  
the keyhole slot shown to hang each speaker on a  
screw that’s securely screwed into the wall.  
To mount the center speaker horizontally, use the two  
keyhole slots shown to hang each speaker on two  
screws that are securely screwed into the wall.  
Caution  
This RCA input should be connected to  
the subwoofer pre out on your AV  
receiver with supplied RCA cable.  
• A mounting screw’s ability to support a speaker  
depends on how well it’s anchored to the wall. If you  
have hollow walls, screw each mounting screw into a  
stud. If there are no studs, or the walls are solid, use  
suitable wall anchors. Use screws with a head diameter  
of 9 mm or less and a shank diameter of 4 mm or less.  
With hollow walls, use a cable/pipe detector to check  
for any power cables or water pipes before making any  
holes.  
Wall  
Caution  
Keyhole slots for wall mounting  
• The front grille is not designed to be removed so does not attempt  
to remove it forcibly, as this will damage it.  
5 to 10 mm  
Keyhole slots for  
wall mounting  
Note  
SKC-980  
• The Auto Standby function turns the subwoofer on when the input signal  
exceeds a certain level. If the Auto Standby function does not work reli-  
ably, try slightly increasing or decreasing the subwoofer output level on  
your receiver.  
• If the Standby/On indicator lights (both red and blue LEDs) several sec-  
onds or minutes after the sound output stopped, this means that the amp  
protection circuit has been activated. In this case, set the OUTPUT LEVEL  
control to the center position, and disconnect the power cord from the AC  
outlet. Wait at least 10 seconds, and then reconnect the power cord. If that  
doesn’t solve the issue, contact your Onkyo dealer.  
260 mm  
• Leave a gap of between 5 mm and 10 mm between the wall and the base  
of the screw head, as shown. (We recommend that you consult a home  
installation professional.)  
SKF-980  
SKR-980  
Using the Cork Spacers for a More Stable Platform  
We recommend using the supplied cork spacers to achieve the best possible  
sound from your speakers. The cork spacers prevent the speakers from mov-  
ing, providing a more stable platform.  
Attaching and detaching the speaker grilles  
The front, center and surround  
speakers have detachable grilles.  
See the right illustrations to attach  
or detach them.  
Setting the Subwoofer Level  
Removal  
Replacement  
Make sure the SKW-938 subwoofer’s output  
level control is set at the “THX-POSITION”.  
You can then adjust the level as needed.  
Cork spacers  
Bottom of the  
SKF-980  
Bottom of the SKC-980  
Cork spacers  
Enjoying Home Theater  
Specifications  
The Home Theater means that you can enjoy surround sound with a real sense of movement in your own home — just like being in  
a movie theater or concert hall.  
Powered Subwoofer (SKW-938)  
Center Speaker (SKC-980)  
Type  
Acoustic suspension  
Type  
2 Way Acoustic suspension  
Rated output power (IEC)  
125 watts minimum continuous power,  
6 ohms, driven at 100 Hz with a  
maximum total harmonic distortion of  
1 %  
Impedance  
Maximum input power  
Sensitivity  
Frequency response  
Crossover frequency  
Cabinet capacity  
Dimensions (W × H × D)  
8 Ω  
130 W  
abFront left and right speakers (SKF-980)  
f
ab c  
They should be positioned facing the listener at about ear level, and equally  
spaced from the TV. Angle them inward slightly so as to create a triangle, with  
the listener at the apex.  
83 dB/W/m  
50 Hz to 45 kHz  
2 kHz  
Input sensitivity/impedance 280 mV / 20 kΩ  
Frequency response  
Cabinet capacity  
c
Center speaker (SKC-980)  
20 Hz to 100 Hz  
49 L  
Position it close to your TV (preferably on top) facing forward at about ear  
level, or at the same height as the front left and right speakers.  
deSurround left and right speakers (SKR-980)  
7.5 L  
433 mm × 158 mm × 199 mm  
(incl. grille and projection)  
Dimensions (W × H × D)  
380 mm × 444 mm × 429 mm  
(incl. grille and projection)  
Position them at the sides of the listener, or slightly behind, about 60 to 100 cm  
above ear level. Ideally they should be equally spaced from the listener.  
Weight  
Drivers unit  
5.3 kg  
Weight  
15.5 kg  
12 cm A-OMF Cone Woofer × 2  
2.5 cm Soft Dome Tweeter × 1  
Binding post (Banana type supported)  
Magnetic shielding  
Drivers unit  
Power supply  
Power consumption  
Other  
30 cm Cone Woofer  
AC 230 V, 50 Hz  
137 W  
f
Subwoofer (SKW-938)  
Terminal  
Other  
The subwoofer handles the bass sounds of the LFE (Low-Frequency Effects)  
channel. The volume and quality of the bass output from your subwoofer will  
depend on its position, the shape of your listening room, and your listening  
position. In general, a good bass sound can be obtained by installing the sub-  
woofer in a front corner, or at one-third the way along the front wall, as shown.  
Corner  
position  
1/3 of wall  
position  
Auto Standby function  
Front Speakers (SKF-980)  
Surround Speakers (SKR-980)  
Type  
Impedance  
2 Way Acoustic suspension  
Type  
Impedance  
2 Way Acoustic suspension  
de  
8 Ω  
130 W  
8 Ω  
130 W  
Maximum input power  
Sensitivity  
Frequency response  
Crossover frequency  
Cabinet capacity  
Dimensions (W × H × D)  
Maximum input power  
Sensitivity  
Frequency response  
Crossover frequency  
Cabinet capacity  
Dimensions (W × H × D)  
83 dB/W/m  
50 Hz to 45 kHz  
2 kHz  
81 dB/W/m  
50 Hz to 45 kHz  
2 kHz  
Connecting the Speakers  
7.5 L  
4.6 L  
158 mm × 433 mm × 199 mm  
(incl. grille and projection)  
200 mm × 275 mm × 169 mm  
(incl. grille and projection)  
Surround  
left  
speaker  
Surround  
right  
speaker  
Front left  
speaker  
Front right  
speaker  
Weight  
Drivers unit  
5.3 kg  
Weight  
Drivers unit  
3.5 kg  
12 cm A-OMF Cone Woofer × 2  
2.5 cm Soft Dome Tweeter × 1  
Binding post (Banana type supported)  
Magnetic shielding  
13 cm A-OMF Cone Woofer × 1  
2.5 cm Soft Dome Tweeter × 1  
Binding post (Banana type supported)  
Terminal  
Other  
Center speaker  
Terminal  
Specifications and appearance are subject to change without  
prior notice.  
THX and the THX logo are trademarks of THX Ltd. which are regis-  
tered in some jurisdictions. All rights reserved.  
Blue  
Gray  
White  
Red  
Green  
Speaker Connection Precautions  
Read the following before connecting your  
speakers:  
• Turn off your receiver before making any  
connections.  
Sales & Product Planning Div. : 2-1, Nisshin-cho, Neyagawa-shi, OSAKA 572-8540, JAPAN  
Tel: 072-831-8023 Fax: 072-831-8163  
ONKYO U.S.A. CORPORATION  
• Pay close attention to speaker  
wiring polarity. Connect positive  
(+) terminals to only positive (+)  
terminals, and negative (–) ter-  
minals to only negative (–) terminals. If the  
speakers are wired incorrectly, the sound  
will be out of phase and will sound unnatu-  
ral.  
18 Park Way, Upper Saddle River, N.J. 07458, U.S.A.  
Tel: 800-229-1687, 201-785-2600 Fax: 201-785-2650 http://www.us.onkyo.com/  
Powered  
subwoofer  
ONKYO EUROPE ELECTRONICS GmbH  
Liegnitzerstrasse 6, 82194 Groebenzell, GERMANY  
ONKYO EUROPE ELECTRONICS GmbH (UK BRANCH)  
The Coach House 81A High Street, Marlow, Buckinghamshire, SL7 1AB, UK  
Tel: +44-(0)1628-473-350 Fax: +44-(0)1628-401-700  
• Be careful not to short the positive and nega-  
tive wires. Doing so may damage your amp.  
ONKYO CHINA LIMITED  
Unit 1 & 12, 9/F, Ever Gain Plaza Tower 1, 88, Container Port Road, Kwai Chung,  
N.T., Hong Kong. Tel: 852-2429-3118 Fax: 852-2428-9039  
Note  
Y1006-1  
• When you connect the surround back and front  
high speakers, prepare for it separately.  
SN 29400482  
(C) Copyright 2010 ONKYO CORPORATION Japan. All rights reserved.  
* 2 9 4 0 0 4 8 2 *  
 

Miele Dishwasher G 2872 User Manual
MTD Lawn Mower 110 072 300 User Manual
MTD Trimmer 710 700 User Manual
National Instruments Computer Accessories 3x User Manual
Newcon Optik Hunting Equipment NVS 14 3AG User Manual
Niles Audio Speaker RS6 Series User Manual
Oki Printer 6200n User Manual
Omega Engineering Plumbing Product BV70 User Manual
Onkyo Blu ray Player BD SP309 User Manual
Panasonic Security Camera DMC FZ200 User Manual