Onkyo Car Speaker D N10BX User Manual

D-N10BX,N9BX,N7BX_En.fm Page 1 Thursday, May 25, 2006 5:42 PM  
Before UsingYour New Speakers  
Speaker System  
• The speaker cabinets are made out of  
wood and are therefore sensitive to  
extreme temperatures and humidity.  
Do not use them in locations subject to  
direct sunlight or in humid places,  
such as near an air conditioner, humid-  
ifier, bathroom, or kitchen.  
D-N10BX  
D-N9BX  
D-N7BX  
• Place the speakers on sturdy, flat sur-  
faces. Putting them on uneven or  
unstable surfaces where they may fall  
and cause damage will affect the  
sound quality.  
• Do not keep water or other liquids  
close to the speakers. If a liquid is  
spilled over them, the woofer and  
tweeter inside may be damaged.  
• Do not handle the speakers with wet or  
damp hands.  
Instruction Manual  
Thank you for purchasing an Onkyo Speaker  
System.  
Please read this manual thoroughly before using  
it. Following the instructions in this manual will  
enable you to obtain optimum performance and  
listening enjoyment from your new Speaker Sys-  
tem.  
Please retain this manual for future reference.  
En  
 
D-N10BX,N9BX,N7BX_En.fm Page 3 Thursday, May 25, 2006 5:42 PM  
Connecting the Speakers  
Speaker Placement  
• Before connecting the speakers, disconnect your  
amplifier’s power cord from the wall outlet and set its  
volume control to minimum.  
• The speaker’s rated impedance is 4. Make sure you con-  
nect an amplifier that is compatible with a 4impedance.  
The sound quality of the speakers is directly affected by  
the size and shape of the room they’re used in and its  
furnishings. When considering where to place your  
speakers, read the following:  
• Where possible, mount the speakers on speaker  
stands, concrete blocks, bricks, or a sturdy bookshelf.  
Putting them directly on the floor will emphasize bass  
sounds, creating a boomy sound.  
• Use the supplied speaker cables to connect the speak-  
ers to your amplifier as shown.  
• If a speaker is placed on an uneven surface where it  
can wobble or vibrate, bass performance will be  
adversely affected.You can eliminate speaker wobble  
by putting a shim made out of cork or metal, such as a  
coin, underneath the speaker or stand, as shown.  
1.Peel the  
insulation off  
the ends of  
the speaker  
cable and  
twist the  
2.Loosen the  
terminal screw  
and insert the  
speaker cable  
into the hole  
(until the core  
wires are  
3.Fasten the  
terminal  
screw.  
core wires.  
inserted fully).  
Shim  
Right speaker  
Left speaker  
Positive (+) side is  
indicated by a  
red line  
• If you mount the speakers on a flat surface, such as a  
bookshelf, you can improve the sound quality by  
inserting cork spacers or coins in between the speaker  
and the shelf. Raising them off the surface like this  
will reduce the contact area and improve the sound.  
D-N10BX  
shown  
• If you like lots of bass, mount the speakers on low  
speaker stands and place them in front of a solid wall.  
Speaker cable  
• Walls and furnishings affect sound quality. To achieve  
a good stereo sound, put the left and right speakers in  
similar locations at the same distance away from your  
listening position and at the same height. If you put  
them in totally different locations, for example, one  
on the floor and the other on a bookshelf, the stereo  
imaging will be adversely affected.  
• To determine the best positions for your speakers,  
imagine an equilateral triangle and put the left and  
right speakers at the ends of the base. The ideal listen-  
ing position is at or slightly behind the triangle’s  
apex. Angle the speakers toward your listening posi-  
tion.  
The type of speaker terminals used on the receiver and  
their position depends on the model. Refer to the  
receiver’s instruction manual for details on connecting  
speakers to the receiver.  
• Glass doors and smooth walls behind the listening  
position can reflect the sound from the speakers and  
can make sounds at certain frequencies louder. You  
can prevent this by hanging sound-absorbing mate-  
rial, such as thick curtain, on the door or wall.  
Before Turning on Your Receiver:  
• Make sure the speaker’s positive (+) terminals are  
connected to the amplifier’s positive (+) terminals,  
and the speaker’s negative (–) terminals are con-  
nected to the amplifier’s negative (–) terminals. If you  
get the polarity reversed, the sound will be unnatural,  
with a limited bass range and poor stereo image.  
• Make sure that the positive (+) and negative (–) wires  
are not touching each other. If they are, a short circuit  
may occur, damaging your amplifier.  
D-N10BX  
• Please note that the speakers’ surface features a spe-  
cial finish. An object placed on the speakers for a  
long period of time may leave a trace or mark. Adhe-  
sive tape may also leave a mark.  
3
 
D-N10BX,N9BX,N7BX_En.fm Page 4 Thursday, May 25, 2006 5:42 PM  
Frequency response:  
Crossover frequency:  
Cabinet capacity:  
45 Hz–100 kHz  
6 kHz  
8.1  
Care  
• D-N9BX/D-N7BX  
Dimensions (W × H × D): 167 × 298 × 247 mm  
To maintain the appearance of the speakers, you should  
periodically wipe them with a soft, dry cloth. Stubborn  
stains can be removed by using a soft cloth dampened  
with water and a mild detergent. Dry the speakers  
immediately afterward with a clean, dry cloth. Do not  
use abrasive cloths, thinners, alcohol, or other chemical  
solvents that may damage the finish.  
(incl. grille)  
Weight:  
D-N10BX: 4.2 kg (9.2 lbs)  
D-N9BX: 4.1 kg (9.0 lbs)  
Woofer: 13 cm A-OMF MONO-  
COQUE type  
Speakers  
Tweeter: 3 cm ring drive  
Nut-type binding posts,  
compatible with banana  
plugs  
Terminal:  
• D-N10BX  
From time to time you should wipe off the front and  
rear panels and the cabinet with a soft cloth. For heavier  
dirt, dampen a soft cloth in a weak solution of mild  
detergent and water, wring it out dry, and wipe off the  
dirt. Following this, dry immediately with a clean cloth.  
Do not use rough material, thinners, alcohol or other  
chemical solvents or cloths since these may damage the  
finish or remove the panel lettering.  
Accessories:  
1.8 meter speaker cable × 2  
Cork spacer × 8  
Instruction Manual × 1  
Magnetic shielding  
Others:  
D-N7BX  
Type:  
Impedance:  
Maximum input power:  
2-way bass reflex  
4 Ω  
70 W  
Dust in inaccessible places can be removed by carefully  
using a vacuum cleaner.  
Output sound pressure level: 83 dB/W/m  
To maintain the appearance, use a commercially avail-  
able piano cleaner designed for glossy surfaces. This  
will cleanly remove finger marks and smudges, restor-  
ing the beautiful luster of the surface. This will also  
make it more difficult for dust and finger marks to  
adhere, allowing you to easily remove them with a dry  
cloth if they should occur.  
Frequency response:  
Crossover frequency:  
Cabinet capacity:  
50 Hz–100 kHz  
6 kHz  
8.1  
Dimensions (W × H × D): 167 × 290 × 246 mm  
(incl. grille)  
Weight:  
Speakers  
3.9 kg (8.6 lbs)  
Woofer: 13 cm A-OMF MONO-  
COQUE type  
Tweeter: 3 cm ring drive  
Nut-type binding posts,  
compatible with banana  
plugs  
Terminal:  
Accessories:  
Others:  
Specifications  
D-N10BX/D-N9BX  
1.8 meter speaker cable × 2  
Cork spacer × 8  
Type:  
Impedance:  
2-way bass reflex  
Instruction Manual × 1  
Magnetic shielding  
4 Ω  
70 W  
Maximum input power:  
Output sound pressure level: 84 dB/W/m  
Specifications and appearance are subject to change for  
improvement without prior notice.  
Sales & Product Planning Div. : 2-1, Nisshin-cho, Neyagawa-shi, OSAKA 572-8540, JAPAN  
Tel: 072-831-8023 Fax: 072-831-8124  
ONKYO U.S.A. CORPORATION  
18 Park Way, Upper Saddle River, N.J. 07458, U.S.A.  
Tel: 201-785-2600 Fax: 201-785-2650 http://www.us.onkyo.com/  
ONKYO EUROPE ELECTRONICS GmbH  
Liegnitzerstrasse 6, 82194 Groebenzell, GERMANY  
Tel: +49-8142-4401-0 Fax: +49-8142-4401-555 http://www.eu.onkyo.com/  
ONKYO EUROPE UK Office  
Suite 1, Gregories Court, Gregories Road, Beaconsfield, Buckinghamshire, HP9 1HQ  
UNITED KINGDOM Tel: +44-(0)1494-681515 Fax: +44(0)-1494-680452  
HOMEPAGE  
ONKYO CHINA LIMITED  
Units 2102-2107, Metroplaza Tower I, 223 Hing Fong Road, Kwai Chung,  
N.T., HONG KONG Tel: 852-2429-3118 Fax: 852-2428-9039  
I0605-2  
SN 29344283A  
(C) Copyright 2006 ONKYO CORPORATION Japan. All rights reserved.  
* 2 9 3 4 4 2 8 3 A *  
 

National Instruments Network Card Fieldbus User Manual
Niles Audio Portable Speaker HD5 User Manual
Nilfisk Advance America Boiler GR 8000 User Manual
Nilfisk ALTO Vacuum Cleaner 995 0H M SD XC User Manual
NordicTrack Home Gym NTXC80181 User Manual
Optoma Technology Projector TX536 User Manual
Panasonic Car Video System DVDXV10 User Manual
Panasonic Cordless Telephone KX TC1703B User Manual
Panasonic Fax Machine KX PW513DL User Manual
Parkside Cordless Drill X1 8V User Manual