Omnimount Indoor Furnishings AB2 User Manual

AB2/AB2 HTS INSTALLATION INSTRUCTIONS  
These fasteners and tools are provided  
AB2 HTS  
AB2 HTS  
Step 1  
Identify parts  
(1) (5) M4 X 12mm Phillips  
(2)  
(1)  
(1)  
(10) Plastic anchor  
pan head machine screw  
(1) (5) M5 X 12mm Phillips pan  
head machine screw  
(5) 8-32 X 5/8'' Phillips pan  
head machine screw  
Mounting plate (1)  
(2) (10) #12 X 3/4" Phillips pan  
head self-tapping screw  
(5) Circular nut (PEM)  
8-32 thread  
�  
(2) (10) #12 X 1-3/4'' Phillips pan  
head self-tapping screw  
(1)  
(5) 1/4-20 X 1" Phillips pan  
head machine screw  
(1) (5) 5/32'' Hex key  
(1)  
(2) 3/32'' Drill bit  
Screw covers  
Extension  
��  
Additional installation tools  
Phillips Head Screw Driver  
Pencil  
Adjusting knuckle  
Electric Drill  
Mounting plate (2)  
Drill Bits: 1/8'' drill bit for drywall  
Speaker plate  
1/8”  
5/16'' masonry bit for cement wall applications  
5/16'' mason bit  
Wall  
Ceiling  
Wall  
Step 2  
Decide on location  
Mounting to drywall.  
Step 3 Installation of the wall plate  
1. Use the wall plate as a template and mark the screw hole locations onto the surface using a pencil.  
2. Drill into the drywall with a 1/4'' drill bit. Insert the anchors into the hole as shown in fig. 3.  
3. Secure with the #12 x 1-3/4'' screws, see fig. 4.  
 
 
 
Mounting to solid concrete or cinder block.  
1. Drill into the surface with a 3/16'' masonry drill bit 1-3/4" deep and insert the anchors into the holes as shown in Fig. 3  
2. Secure wall plate with the #12 x 1-3/4" , see fig. 4.  
 
 
 
 
Step 3  
Installation of wall plate (continued)  
Step 4  
Installation of speaker plate onto speaker  
Mounting to solid wood or wood studs.  
Drill a pilot hole into center of each location using 3/32" drill bit (provided),  
Drill 1-1/4'' into stud. Attach the plate with two #12 x 1-3/4" wood screws.  
®
1. Bose speakers with 4MM or 5MM inserts.  
fig. 3  
fig. 2  
 
 
fig. 6  
 
2. Speakers with single factory installed threaded insert.  
fig. 4  
��  
wall  
wall  
 
 
Step 5  
Installation of adjusting knuckle  
and extension.  
3. Speakers with 2 installed 1/4''-20 or 6MM x 15MM threaded inserts.  
Set screw location  
1/4''-20 x 5/8'' or  
6MM x 15MM  
Screw covers  
(not supplied)  
Set screw locations  
4. Speakers with a single keyhole in back.  
Extension  
Insert into keyhole and slide upward then tighten.  
Set screw location  
5. Speakers without mounting holes - wood cabinet only.  
 
#12 x 3/4''  
3/32'' drill bit  
OmniMount Systems, Inc.  
The Pointe at South Mountain  
8201 South 48th Street  
Phoenix, Arizona 85044-5355  
Toll free 1-800-MOUNT-IT  
(480) 829-8000  
100% Replacement Warranty  
Audio Basics products are engineered and manufactured to the highest standards. In the event that there are defects in materials,  
workmanship, or missing parts, OmniMount Systems will, at its discretion, repair or replace your Audio Basics product. Claims that  
are submitted must include either the sales slip or proof of purchase.  
Copyright 2004 OmniMount Systems, Inc.  
All rights reserved. OmniMount products  
are covered by patents issued and/or  
pending. “OmniMount” is a registered  
trademark of OmniMount Systems, Inc.  
"Audio Basics" is a trademark of  
If OmniMount products are used for purposes other than their original intent, OmniMount Systems, its distributors and retailers shall  
not be held responsible or liable for injuries or property damage, direct, indirect or consequential, which may arise from the inability  
to use this product safely, properly, and in the manner for which it has been designed and manufactured.  
This warranty does not apply to products which have been lost, damaged by misuse, abuse or accident, altered or repaired in any  
way other than specified by OmniMount Systems, Inc.  
This warranty is non-transferable.  
For installatioDn aosswisntalnoceapdleafsreocmall Wourwtowll f.rSeeohmelpalinneuaat l1s-8.c00o-mMO.UANTll-ITManuals Search And Download.  
OmniMount Systems, Inc.  
AB-2 revision 2, 1/04 Part #1000254.  
Fax: (480)756-9000  

Miele Ventilation Hood DA 398 5 User Manual
Miglia Technology Cordless Telephone Cordless Phone User Manual
MTX Audio Speaker 525W User Manual
Napoleon Grills Griddle N415 0117 User Manual
National Instruments Digital Photo Keychain 12 Bit 200 MS s Digitizer User Manual
NETGEAR Network Hardware A6200 100NAS User Manual
Nikon Camera Accessories MB D10 User Manual
Nilfisk Advance America Vacuum Cleaner RS 501 User Manual
Oregon Scientific Marine Radio BAR610B User Manual
Patton electronic MP3 Player Accessories 460RC User Manual