NuTone Saw CFVS 1N User Manual

INSTALLATION INSTRUCTIONS  
READ & SAVE THESE INSTRUCTIONS!  
Solid-State  
TO FAN  
BOX  
CONNECTOR  
Speed Control  
MODEL: CFVS-1N  
SINGLE GANG  
SWITCH BOX  
LOW SPEED  
BLK  
BLK  
ADJUSTMENT  
TRIMPOT  
For use with NuTone Model WHV-20  
Whole-House Ventilator.  
WHT  
1. Install single-gang switch box.  
2. Run 120vAC, 60Hz power line to switch box.  
3. Run 14/2 cable from switch box to fan location.  
BLK  
BLK  
4. Refer to wiring diagram and make connections.  
CAUTION: Be sure all wiring complies with local electrical  
codes and switch and fan are properly grounded.  
120vAC, 60Hz  
POWER SOURCE  
SPEED  
5. LOW SPEED ADJUSTMENT: Turn the main control shaft  
fully clockwise. If the fan is not running at the desired  
speed, use an insulated screwdriver to adjust the trimpot  
until the desired speed is achieved (turn clockwise for  
slower, counterclockwise for faster). Make low speed  
adjustment so that the louvers stay open when the  
ventilator is operating.  
CONTROL  
CONTROL  
KNOB  
GREEN  
GROUND  
WHT  
BLK  
120V LINE  
FROM SWITCH  
 

Murphy Switch DF Series User Manual
Mustek Scanner KB4000 User Manual
Niles Audio Car Speaker cm5at User Manual
NordicTrack Treadmill NTL129054 User Manual
One for All TV Video Accessories SV 9380 User Manual
Onkyo Stereo Receiver TX SA706 User Manual
Panasonic DVD Player DVD RV10 User Manual
Panasonic Impact Driver EY7541 User Manual
Panasonic Switch AM1 NZ BASIC User Manual
Patton electronic Network Card 1052AS User Manual