N T S C
Video Network Station
SNT-V501
SNT-V504
RS-232C/485 Interface
Compact and Lightweight Design
Camera control with a serial interface -
The SNT-V501/V504 stations allow control of the
Pan/Tilt/Zoom and camera settings of Sony
EVI-D100/EVI-D70 cameras, and control of the
Sony SSC-DC590 Series cameras.
With compact dimensions of just 128 x 40 x
150 mm (5 1/8 x 1 5/8 x 6 inches) and a light
weight of only 650 g (1 lb 7 oz) (SNT-V501)/
710 g (1 lb 9 oz) (SNT-V504), these Video
Network Stations are suitable for restricted
space or rack installation.
Transparent function -
The SNT-V501/V504 stations have a transparent
function via the RS-232C/485 interface. External
equipment can be connected and controlled by a
PC connected to the network.
PCMCIA Type II Slot*
Memory card - You can increase the storage
capacity of the SNT-V501/V504 stations by
adding either a flash memory card or an ATA
Hard Disk Drive (HDD) card. IC recording media
such as a Memory StickTM media card with a
Memory Stick/PC card adaptor can also be used.
Network Security Feature
User access to video cameras via the
SNT-V501/V504 stations can be limited by IP
filtering. Up to ten different groups can be
established by defining an IP address for each
group. Additionally, user names and passwords
can be assigned to allow four levels of access.
Wireless card - The SNT-V501/V504 stations are
compatible with certain IEEE 802.11b-compliant
wireless PC cards.
* Please contact your local Sony office or authorized dealer
for the memory and the wireless cards compatible with
the SNT-V501/V504.
OTHER FEATURES
“Tour“ Feature -
This allows the user to preset up to five scanning
patterns with up to 16 positions in each scan.
“Area setting“ Feature -
This allows the administrator to design an area
within the image to be cropped, which is
particularly useful when you wish to monitor a
specific location.
Viewing from a PDA
Images can be viewed from a PDA running
Microsoft Pocket PC® 2003.*
Alarm Function
The SNT-V501/V504 are equipped with a built-in,
activity-detection function that can be set to
generate an alarm through its alarm-output
ports. In addition, with a sensor-input port that
can receive a trigger from an external sensor and
a built-in 8-MB buffer, the SNT-V501/V504
stations can store hundreds of pre-alarm and
post-alarm still images at the time an alarm is
triggered -whether from the activity-detection
function, the alarm-input port, or both. Pre-/post-
alarm images can then be transferred to an FTP
server.
* The Jeode plug-in Ver. 1.9.1 is required for viewing images.
REAR PANEL
SNT-V501
SNT-V504
SYSTEM CONFIGURATION
Single Camera
Operation over LAN
Video Monitor
Video out
(Coaxial cable)
Video out
(Coaxial cable)
Ethernet
Color Video
Camera
SSC-DC590
Series
EVI-D70/
EVI-D100
RS-232C*
SNT-V501
SNT-V504
Ethernet
Multiple Camera
Operation over LAN
LAN
Video out
(Coaxial cable)
PC
RS-232C*
EVI-D70/EVI-D100
Video out
(Coaxial cable)
Ethernet
Video out
(Coaxial cable)
Color Video Cameras/
SSC-DC590 Series
Video out
(Coaxial cable)
Video Monitor
* Only Sony SSC-DC590 Series, EVI-D70, and EVI-D100 cameras can be controlled using the RS-232C interface.
SPECIFICATIONS
SNT-V501
SNT-V504
Analog Video Interface
Video input
(1) Analog composite (BNC x 1),1.0 Vp-p, 75 ohms,
unbalanced, sync negative Auto sensing for NTSC
Through video output: Analog composite (BNC x 1),
1.0 Vp-p, 75 ohms, unbalanced, sync negative
(4) Analog composite (BNC x 1),1.0 Vp-p, 75 ohms,
unbalanced, sync negative Auto sensing for NTSC
Analog composite (BNC x 1),1.0 Vp-p, 75 ohms,
unbalanced, sync negative (QUAD/Single selectable)
Video ouput
System/Network
CPU
32-bit RISC processor
RAM
32 MB (including 8 MB alarm buffer)
Flash memory
Image size
Compression method
Compression ratio
Frame rate
8 MB
NTSC 704 x 480, 640 x 480, 320 x 240, 160 x 120
JPEG
Approx. 1/5 to 1/60 (10 steps) * The compression ratio is based on an image of 24 bits/picture element (8 bits for each R, G and B).
NTSC Max. 30 fps (640 x 480)
Protocols
Number of client
Interface
TCP/IP, ARP, ICMP, HTTP, FTP (server/client), SMTP, DHCP, DNS, NTP, SNMP (MIB-2)
Max. 50
Ethernet
100BASE-TX/10BASE-T (RJ-45)
Sensor input
(1) 3.3 to 24 V DC device supported,
(4) 3.3 to 24 V DC device supported,
photo coupler inputs electrically isolated from this unit
photo coupler inputs electrically isolated from this unit
Alarm output
Serial interface
PC card slot
(2) 24 V DC or less, 1 A, mechanical relay outputs electrically isolated from the camera
RS-485/RS-232C (for camera control or transparency function)
PCMCIA Type II(1)
General
Weight
Approx. 1 lb 7 oz (650 g)
Approx. 1 lb 9 oz (710 g)
Dimensions(W/H/D)
Power requirement
Power consumption
Operating temperature
Storage temperature
Operating humidity
Storage humidity
Supplied accessories
5 1/8 x 1 5/8 x 6 inches (128 x 40 x 150 mm) excluding protruding parts
DC 12 V or AC 24 V
10.0 W max.
14.0 W max.
14°F to 122°F (-10 to 50°C) When PC card is attached: 14 to 104°F (-10 to 40°C)
-4 to 140°F (-20 to 60°C)
20 to 80 %, Non-condensing
20 to 95 %, Non-condensing
CD-ROM (setup program and User's Guide) (1), I/O receptacle (1), Installation manual (1)
©2004 Sony Corporation. All rights reserved.
Reproduction in whole or in part without written permission is prohibited.
Features and specifications are subject to change without notice.
All non-metric weights and measurements are approximate.
Some images in this catalog are simulated.
®
Sony Electronics Inc.
Park Ridge, NJ 07656
1-800-686-7669
Sony is a registered trademark of Sony Corporation.
Memory Stick is a trademark of Sony Corporation.
All other trademarks are the property of their respective owners.
S-SNTV501/V504
MK10092V2IW04MAY
Printed in USA (8/04)
|