Network Technologies Switch SE DVI 2 User Manual

1275 Danner Dr Tel:330-562-7070  
R NETWORK  
Fax:330-562-1999  
TECHNOLOGIES Aurora, OH 44202  
INCORPORATED  
NTI  
VIDMUX® Series  
SE-DVI-2  
2 Port DVI Video Switch  
Installation and Operation Manual  
MAN068 Rev Date 5/24/2006  
 
TABLE OF CONTENTS  
Introduction......................................................................................................................................................................1  
Materials..........................................................................................................................................................................1  
Features And Functions ..................................................................................................................................................1  
Installation .......................................................................................................................................................................2  
Operation.........................................................................................................................................................................3  
Troubleshooting...............................................................................................................................................................4  
Product Specification.......................................................................................................................................................4  
Warranty Information.......................................................................................................................................................4  
ii  
MAN0068 Rev Date5/24/2006  
 
NTI VIDMUX Series 2-Port DVI Video Switch  
INTRODUCTION  
The VIDMUX Series SE-DVI-2 (VIDMUX) is a 2-port DVI video switch that enables two video sources such as a PC or HDTV  
tuner to share one DVI monitor using DVI-I or DVI-D single-link connectors. The DVI interface technology implements digital signal  
transmission over the cable to eliminate noise and reduce undesired distortion.  
See our catalog, visit our website at http://www.networktechinc.com, or contact an NTI sales representative at 800-742-8324 (800-  
RGB TECH) or 330-562-7070 for more details.  
MATERIALS  
Materials Supplied with this kit:  
NTI SE-DVI-2 2 Port DVI Video Switch  
120VAC or 240VAC at 50 or 60Hz-5VDC/2.0A AC Adapter  
Line cord, country specific  
This owners manual  
Materials Not Supplied, but REQUIRED:  
Three DVI-I/DVI-D interface cables ARE REQUIRED but not supplied.  
-
VI-IS-xx-MM for video interface  
DVI-I cable  
Where:  
xx is the length of the cable in feet  
MM indicates male-to-male connector  
All cables can be purchased from Network Technologies Inc by calling 800-RGB-TECH (800-742-8324) or (330)-562-7070.  
FEATURES AND FUNCTIONS  
Rear View of SE-DVI-2  
Front View of SE-DVI-2  
Video 1  
Monitor  
Video 2  
R
NTI  
Network Technologies Inc  
R
VIDMUX  
R
NETWORK  
5VDC  
+
TECHNOLOGIES  
INCORPORATED  
NTI  
1275 Danner Dr Tel:330-562-7070  
Aurora, OH 44202 Tel:800-742-8324  
1
2
2
4
5
1
3
1. Input Select LEDs- for visual indication of the video input selected.  
2. Input Select Switches- push to manually switch to a specific video input  
3. 5VDC- 2.0A jack - connection jack for the AC adapter  
4. MONITOR- DVI female connector for connection of the user monitor  
5. Video Input- DVI female connectors for connecting video cables from DVI video sources  
1
 
NTI VIDMUX Series 2-Port DVI Video Switch  
INSTALLATION  
The VIDMUX is a Plug-and-Play device with no special configuration settings and easy installation steps:  
1. Before connecting the VIDMUX to the video sources, make sure the video sources and the monitor are turned OFF.  
WARNING! Damage may occur to the CPU if power is not disconnected before connecting or disconnecting  
!
cables.  
2. Connect the monitor to the DVI female port labeled “MONITOR” on the rear panel of the VIDMUX using a male-to-male DVI-I  
cable.  
Note: Some monitors need to have their video input type set manually. In this case, select “Digital DVI” as the input  
type.  
Mating Face of  
DVI Female  
Rear View of SE-DVI-2  
Video 1  
Monitor  
Video 2  
R
NETWORK  
TECHNOLOGIES  
INCORPORATED  
5VDC  
+
NTI  
1275 Danner Dr Tel:330-562-7070  
Aurora, OH 44202 Tel:800-742-8324  
DVI Enabled  
Monitor  
Mating Face of  
DVI Male  
3. Connect the video sources to their corresponding DVI ports labeled “VIDEO 1" and/or "VIDEO 2" on the rear panel of the  
VIDMUX using male-to-male DVI-I cables.  
Rear View of SE-DVI-2  
Video 1  
Monitor  
Video 2  
R
NETWORK  
TECHNOLOGIES  
INCORPORATED  
5VDC  
+
NTI  
1275 Danner Dr Tel:330-562-7070  
Aurora, OH 44202 Tel:800-742-8324  
DVI-IS-xx-MM  
DVI-IS-xx-MM  
PC WITH DVI  
VIDEO PORT  
Mating Face of  
DVI Male  
HDTV Tuner  
2
 
NTI VIDMUX Series 2-Port DVI Video Switch  
4. Plug the 5VDC AC adapter into the power jack on the rear panel.  
Rear View of SE-DVI-2  
Video 1  
Monitor  
Video 2  
R
NETWORK  
5VDC  
TECHNOLOGIES  
INCORPORATED  
+
NTI  
Tel:330-562-7070  
1275 Danner Dr  
Aurora, OH 44202 Tel:800-742-8324  
5 VDC  
Barrel  
AC  
ADAPTER  
Power Connector  
5VDC @ 2.0A OUTPUT  
(Outside  
barrel)  
(Inside  
barrel)  
2.1 mm x 5.5 mm Female  
5. Power up the VIDMUX first.  
6. Power up the monitor.  
7. Power up one or both of the video sources.  
Note: If one or both of the video sources is a PC, make sure the LED associated with that source is illuminated while the  
PC boots up. Otherwise the PC may not properly initialize with the connected monitor. See OPERATION below.  
OPERATION  
Press the input select buttons to switch between video sources. The LED above each button will illuminate to indicate which  
source is connected to the monitor.  
Only one source can be connected at a time.  
Note: While booting up a PC, it is recommended that the monitor be connected to the PC (corresponding LED should be  
illuminated) in order for the PC to properly initialize with the connected monitor.  
Front View of SE-DVI-2  
R
NTI  
Network Technologies Inc  
LED indicates  
R
Source at  
VIDMUX  
VIDEO 1  
is connected  
1
2
3
 
NTI VIDMUX Series 2-Port DVI Video Switch  
TROUBLESHOOTING  
If the VIDMUX is not working properly, please look for a solution in the list below:  
PROBLEM:  
SOLUTION:  
No video at all  
Check cable connections on each video source, monitor and the VIDMUX. After reconnecting, if a CPU is the  
video source, the CPU may need to be re-booted in order to sense the monitor connection.  
PROBLEM:  
SOLUTION:  
No video on one port  
Check cable connections on that port. Power cycle the corresponding video source while that port is connected  
(the Input Select LED for that port should be illuminated)  
PROBLEM:  
SOLUTION:  
Some artifacts in the picture  
Check for any loose connection between cable and connectors. If loose, it may be necessary to reboot the CPU  
to achieve a clear image.  
If a solution was not found in the list above, answers may be found in the Frequently Ask Questions (FAQs) section of our  
website at http://www.networktechinc.com or call us directly at (800) 742-8324 (800-RGB-TECH) or (330) 562-7070 and we will be  
happy to assist in any way we can.  
PRODUCT SPECIFICATION  
Video Source Connector  
Monitor Port Connector  
Operating Temperature  
Maximum Display Resolution  
Power Supply  
2 x DVI-I Single Link (Digital Only)  
1 x DVI-I Single Link (Digital Only)  
0-45ºC  
1600x1200, 1080i  
120VAC or 240VAC at 50 or 60Hz-5VDC/2.0A Positive-tip AC Adapter  
Electro-galvanized steel black powdercoated  
5.7x4.5x1.8  
Case Material  
Dimension ( WxDxH) (In.)  
WARRANTY INFORMATION  
The warranty period on this product (parts and labor) is one (1) year from the date of purchase. Please contact Network  
Technologies Inc at (800) 742-8324 (800-RGB-TECH) or (330) 562-7070 or visit our website at http://www.networktechinc.com  
for information regarding repairs and/or returns. A return authorization number is required for all repairs/returns.  
SERIAL NO.:  
DATE:  
INSPECTED BY: _______  
Man068 Rev 5/24/06  
4
 

Miele Iron B 890 User Manual
Milnor Washer K28 0010 User Manual
Murphy Network Card Series 1501 User Manual
Oki Air Compressor C5510 User Manual
One for All Universal Remote OARN05G User Manual
Onkyo Car Satellite TV System CS 245 User Manual
Oregon Scientific Clock AS 316NE User Manual
Panasonic Fax Machine KX F900 User Manual
Panasonic Network Card MALT062HG User Manual
Paradigm Speaker OM 560 User Manual