U s e r ’s M a n u a l
Model
SC2
C e n t e r C h a n n e l L o u d s p e a k e r
Finally, connect the speaker to your amplifier or receiver,
connecting the conductors "in-phase" (+ to + and - to -).
You'll see that your speaker wires have some sort of
marking -- lettering, ridges, or color difference -- to help
you properly wire your speaker in phase.
_
+
Before powering up your amplifier or receiver, separate
different kinds of cables to minimize noise. Keep
speaker wires at the maximum practical distance from
line-level, digital, and power cables, and if they must
cross, keep them at right angles.
Fig. 3
Operation
The NHT SC2 is compatible with virtually all quality
amplifiers, and is designed to handle a wide range of
listening levels.
However, every speaker has limits, and it's important to
listen for them. Speaker damage most often results not
from brief loud musical peaks, but from sustained high
volume levels in some or all frequencies. For this
reason, extreme volume settings and excessive bass,
treble or equalizer boosts are not recommended.
TV
bottom corners. These five slip-resistant contact points
should allow you to place the SC2 in a flush and angled
position on most TV's without scratching or endangering
either speaker or TV. As in all component placement,
however, review safety and stability before considering
your system setup complete.
If you hear unusual distortion or breakup, or notice heat
coming from either your woofer or tweeter, decrease the
volume immediately, neutralize any excess bass, treble
or equalizer boosts, and avoid setting any controls to
similar extremes again.
Connections
Maintenance
Before connecting the SC2 loudspeaker to your system,
turn off the power to your amplifier/receiver to avoid
damaging the components or the speaker.
Your speaker requires no or minimal maintenance under
normal use, as long as you avoid exposing it to direct
sunlight, high temperatures, or moisture. Clean the
cabinet, when necessary, using a damp cloth or a mild,
non-abrasive cleaner. To clean the grille, remove it from
the speaker and use a soft brush or a vacuum on its
First, take a look at the five-way binding posts on the
back of your speaker. They accept raw wire, banana
plugs or spade plugs. Note that nuts should be tightened
by hand, since pliers can strip or break them.
lowest setting.
drivers.
Do not attempt to clean the actual
Next, choose your speaker wire. Like all wire, speaker
wire is rated by a gauge number representing how many
fit in an inch-thick tube, so the numbers get smaller as
the wire gets thicker. Thicker wire transmits signal more
easily. We recommend 16-gauge for shorter runs, and
thicker for runs longer than 10 feet (your authorized NHT
dealer can help with wire). Equal lengths of wire for all
speakers is ideal, but not absolutely necessary.
Satisfaction
Your satisfaction with your new NHT SC2 loudspeaker is
important to us. Please note the warranty, printed on the
back of this manual. And again, if you have any
questions regarding your speakers' use, feel free to call
NHT at 1-800-NHT-9993 or visit our website;
Prepare the wires by stripping 1/4" to 3/8" of insulation
from the ends, tightly twisting the exposed wire strands.
S p e c i f i c a t i o n s
All Super Series products are sonically matched for seamless integration into multichannel systems.
Super Series
SB1
SB2
SB3
ST4
SC1
SW10
SW12
SC2
Vented /
Powered - 150 watts
Class G Amplifier
Vented /
Powered - 250 watts
Class G Amplifier
System Type
2-Way Acoustic
Suspension
2-Way Acoustic
Suspension
2-Way Acoustic
Suspension
3-Way Acoustic
Suspension
2-Way Acoustic
Suspension
2-Way Acoustic
Suspension
Driver Complement
Tweeter-
1” fluid cooled aluminum dome tweeter with neodymium magnet structure
Woofer-
5.25”
Polypropylene
6.5”
Polypropylene
6.5”
Polypropylene
6.5” and 8”
Polypropylene
(8” Not Video Shielded)
(2) 4.5”
Polypropylene
10”
Aluminum
(Not Video Shielded)
12”
Aluminum
(Not Video Shielded)
(2) 5.25”
Polypropylene
Video Shielded Unless Noted
Response
68Hz - 22kHz
+/- 3dB
51Hz - 22kHz
+/- 3dB
39Hz - 22kHz
+/- 3dB
31Hz - 22kHz
+/- 3dB
78Hz - 22kHz
+/- 3dB
31Hz - 180Hz
+/- 3dB
73Hz - 22kHz
+/- 3dB
27Hz - 180Hz
+/- 3dB
Sensitivity
Impedance
86dB / 2.83v
86dB / 2.83v
86dB / 2.83v
86dB / 2.83v
86dB / 2.83v
87dB / 2.83v
8 ohm nominal
8 ohm nominal
8 ohm nominal
8 ohm nominal
8 ohm nominal
8 ohm nominal
Recommended
Amplifier Power
Minimum 15 watts
Maximum 175 watts
Minimum 15 watts
Maximum 200 watts
Minimum 15 watts
Maximum 150 watts
Minimum 15 watts
Maximum 125 watts
Minimum 15 watts
Maximum 150 watts
Minimum 15 watts
Maximum 175 watts
Weight
8 lbs.
13 lbs.
16 lbs.
47.5 lbs.
11 lbs.
39.5 lbs.
47.5 lbs.
22 lbs.
Dimensions
8.75 x 7.5 x 11.85
10 x 8 x 13
12 x 8 x 38
6.63 x 16.54 x 5.63
14 x 12 x 18
6.75 x 6.25 x 10.25
16 x 14 x 20
8.5 x 19 x 6.5
Depth” x Width” x Height”
Finish
White or Black
High Gloss Piano
Finish
White or Black
High Gloss Piano
Finish
Black
High Gloss Piano
Finish
Black
High Gloss Piano
Finish
Black
High Gloss Piano
Finish
Black
High Gloss Piano
Finish
Black
High Gloss Piano
Finish
Black
High Gloss Piano
Finish
Limited Warranty
Valid Only in the U.S.A.
Warranty Period
For a period of 5 years for parts and 5 years for labor (1 year parts and 90 days labor for electronics) from the date this product is first purchased from an author-
ized NHT dealer, Now Hear This (NHT) warrants that if it fails to function properly due to a manufacturing defect, despite its being installed and operated accord-
ing to these instructions and used under normal conditions, it will be either replaced or repaired with new or rebuilt parts (both at NHT's option) with a unit of
comparable value without charge to you.
What's Not Covered
Altered, defaced or removed serial numbers void this warranty.
This warranty does not cover any product used in trade, business, industrial or commercial applications.
This warranty also does not cover the cabinet or appearance factors, or costs, defects or damage resulting from misuse, abuse, accident, improper mainte-
nance, alterations or modifications not authorized in writing by NHT, or parts or labor from any source other than an authorized NHT service location.
Damage due to power exposure in excess of the speaker's published power ratings; ie, overpowering, lightning or power surges, are also not covered.
Your Rights
This warranty gives you specific legal rights, and you may have other rights which vary from state to state.
NHT limits this warranty to the purchase price of the product, excludes incidental or consequential damages, and limits its obligations under any implied war-
ranties under state laws to a period not exceeding their warranty periods. As some states do not allow the above limitations, however, they may not apply to
you.
To Obtain Service
NHT has appointed a number of authorized service companies throughout the USA who can provide warranty service upon your presenting your sales receipt
showing place and date of original owner's transaction.
To find the name and address of the nearest authorized NHT service location, call or write:
AB Tech Services, 17C Airport Drive, Hopedale, MA 01747. 1-800-225-9847
For your future convenience, please keep this warranty with your sales receipt, and record date and place of purchase for further reference.
|