J. Mounting ear for 2-
3. Install the hard disks into the trays.
post rack mounting
)NSTALLATION 'UIDE
K. Disk tray door access
NETGEAR ReadyNAS 1100
L. Disk tray with lock-on
latch
Start here
M. Thumb-screw latch
(system module access)
Follow these instructions to install your NETGEAR® ReadyNAS™ 1100. Then, consult
the ReadyNAS Setup Manual on your Installation CD for instructions on installing the
RAIDar utility and using the FrontView Setup Wizard to configure the ReadyNAS.
Access the ReadyNAS User Guide on the Installation CD to configure any advanced
features. The ReadyNAS User Guide is also on the NETGEAR support site at
N. Cooling fans
O. Power switch
P. Power connection
(100~240VAC,
50/60 Hz)
4. With the latch in the open position, slide the disk trays into the unit completely,
securing the latch and closing the door.
Q. Label (includes serial number and MAC address)
Warning: If you purchased a diskless unit, please read the optional disk installation
section before installing the RAIDar™ utility or connecting ReadyNAS to the network.
R. Ethernet ports (2)
First, check your package contents
Install the hard disks (optional)
Finally, install the RAIDar utility
Before starting installation, check your package contents:
This is an optional step, required only if you purchased a diskless unit.
Your Installation CD contains the RAIDar utility for Windows, MAC and Linux. See the
ReadyNAS Setup Manual for installation instructions. When you complete installation of
the RAIDar utility, you are ready to connect ReadyNAS to your network and then power
on ReadyNAS.
•
•
•
•
•
•
•
•
ReadyNAS 1100
1. Remove disk trays from the unit:
a. Open the door.
Four hard disk trays (not included with diskless units)
Installation Guide
b. Press to release the latch.
c. Pull out the tray.
Warranty Card
Power cable
Connect ReadyNAS
Ethernet cable
2. Set the lock before installing the hard
ReadyNAS Installation CD
disk into the tray (optional).
When connecting ReadyNAS, please note the following:
16 screws for hard disk installation (included only with diskless units)
•
ReadyNAS connected directly to your network: If your client has a static IP
address, make sure it is on the same IP address subnet as the ReadyNAS device. You
can do this by configuring your client to obtain its IP address via DHCP. Even if your
network does not have existing DHCP service, the ReadyNAS device will assure that
you will get an IP address.
Then, take a moment to identify the features of your
ReadyNAS 1100
A. Programmable backup button
F. Ethernet activity LEDs (2)
•
ReadyNAS connected directly to your PC: If you are connecting a PC directly to
ReadyNAS (and not through a network), first set a static IP address on your PC in the
192.168.168.xxx subnet, subnet mask 255.255.255.0. You can then use RAIDar to
detect ReadyNAS, or you can open a browser and enter the ReadyNAS default IP
B. USB ports (3)
G. Power LED
C. USB activity light (1)
H. System reset button
D. Disk LEDs (4). Green for disk online.
E. Activity LED. Blinks for disk access.
I. Power Button (To power off, depress
for 5 seconds or until LED blinks.)
|