NETGEAR Network Router JNR3210 User Manual

Step 2:  
Step 3:  
Step 1:  
Connect one end of the blue  
Ethernet cable to your modem,  
and the other end to the Internet port  
on your router.  
Plug in, then turn on your modem.  
Unplug the power  
to turn off your modem.  
Installation Guide  
Wait approximately 2 minutes  
until your modem turns on.  
N300 Wireless Gigabit Router with USB  
JNR3210  
If your modem has a battery backup,  
first remove and reinsert the battery  
before connecting your  
modem to power.  
Package Contents:  
DSL  
or Cable  
Internet  
N300 Wireless Gigabit  
Router with USB  
N300 Wireless Gigabit Router  
with USB  
Modem  
(not included)  
Step 5:  
Step 4:  
Step 6:  
Connect the router  
to your computer.  
Connect the power adapter to the  
router, then plug it into an outlet.  
Wait until the wireless LED turns  
solid green.  
Open a browser.  
If the Web page does not display,  
Use another Ethernet cable to establish  
a wired connection as shown in this diagram.  
close and re-open the browser  
the address bar, or check the  
“Troubleshooting” section in  
the User Guide.  
Power adapter  
Ethernet cable  
Optionally, connect wirelessly by using the  
preset wireless security settings  
located on the bottom label.  
If none of the LEDs turn on, make sure that  
the Power On/Off button is in the ON position  
(pushed in).  
 

Miele Appliance Trim Kit KM6350 User Manual
Miele Vacuum Cleaner S185 User Manual
MTD Tiller 217 200 User Manual
Nespresso Coffeemaker D50USBKNE User Manual
NETGEAR Switch GS748TNA User Manual
NeumannBerlin Microphone KM D AES 42 User Manual
NuTone Iron AVD40KN User Manual
Omega Thermometer CL3512A User Manual
Panasonic Copier DP 2500 3000 User Manual
Panasonic Network Card AJ HDP2000P User Manual