NETGEAR Network Card WNCE2001 User Manual

WNCE2001_IG.fm Page 1 Friday, April 9, 2010 3:14 PM  
WPS (WiFi Protected Setup) is a simple and secured way to connect a device to an existing network.  
If you have a NETGEAR router, this feature is called Push ‘N’ Connect. Look for the or symbols on the router to make sure  
the NETGEAR router supports WPS. For non-NETGEAR routers, please refer to the user manual to determine if the router supports WPS.  
Once you know whether your router supports WPS, choose the appropriate installation method below.  
What is WPS?  
Universal WiFi Internet Adapter (WNCE2001)  
Package Contents  
Installation with WPS  
Installation without WPS  
Step 1: Please disconnect any wireless connection to the router  
and/or remove the Ethernet cable currently connected to  
the computer. You may restore the connection after the  
WNCE2001 installation is complete.  
Power  
adapter  
Step 1: Connect the WNCE2001  
to your TV, XBox, or Blu-ray  
player using the Ethernet  
cable (included) and one  
of the power connection  
Step 2: Connect the WNCE2001 to your computer, using the  
Ethernet cable (included) and one of the power connection  
options. For more information on power-up methods,  
see “Power Connection Options” on the reverse side.  
options. For more information  
on power-up methods,  
WNCE2001  
see “Power Connection  
Options” on the reverse side.  
Step 2: Push the WPS button on the  
USB power  
Ethernet cable  
cable  
WNCE2001. The WLAN LED  
will blink amber and green,  
showing that the WPS is  
running.  
Top and Back Views  
Step 3: Open your Internet browser and it will automatically take you  
to the setup page. Follow the instructions on the setup page,  
then return to this guide and continue to Step 4.  
Step 3: Push the WPS button on your router. The WLAN LED  
on the WNCE2001 will stay green for  
5 seconds when the wireless connection has been  
established.  
Step 4: Disconnect the Ethernet and USB cables from your computer.  
Step 5: Connect the WNCE2001 to your TV, Box, or Blu-ray player.  
If your device doesn’t have a USB port, see  
WPS  
button  
Step 4: Congratulations! Your installation is complete.  
“Power Connection Options” on the reverse side.  
Reset  
button  
Power  
WPS  
button  
Power  
LED  
Ethernet  
Port  
WLAN  
LED  
LAN  
LED  
Step 6: Congratulations! Your installation is complete.  
 

Miele Food Saver HS12 User Manual
Miele Vacuum Cleaner S 700 series User Manual
Miller Electric Welder D 75S User Manual
Napoleon Grills Gas Grill Gourmet Gas Grill User Manual
NEC Indoor Furnishings NP3150CM User Manual
NEC Marine Instruments PX 42XM4G User Manual
Panasonic Air Conditioner CW XC244HU User Manual
Panasonic Cordless Telephone KX TG5561 User Manual
Panasonic GPS Receiver CN GP50N User Manual
Panasonic Laptop CF 30Mk2 User Manual