NETGEAR Network Card WG511 User Manual

2. Next, install the WG511 Wireless PC Card.  
c. Click on the “Allow me to connect to the selected wireless  
network even though this is not secure” check box.  
a. Hold the PC Card with the Netgear logo facing up and insert  
it into a CardBus slot. After a short delay, the Found New  
Hardware Wizard displays.  
d. Click Connect.  
WG511 54 Mbps Wireless PC Card  
4. Finally, verify wireless network connectivity.  
Note: If a Windows XP  
certified warning appears,  
click Continue Anyway  
to proceed.  
a. Open the WG511 utility by clicking on the icon  
Windows system tray.  
in the  
Quick Installation Guide  
Follow these quick steps to install your WG511  
Note: When the  
Window XP wireless  
configuration utility is  
selected, only these two  
tab pages appear.  
The basic installation and configuration instructions below assume  
that your wireless network connection will be to an access point, and  
you are not using WEP security. Please refer to Reference Manual  
on the Resource CD for detailed instructions on configuring WEP,  
using Ad-hoc mode, or using advanced options.  
You will see the WG511 system tray icon on the  
lower right portion of the Windows task bar.  
To use the full Netgear  
utility, please see the  
Reference Manual on  
the NETGEAR 54 Mbps  
Wireless PC Card  
Windows XP Basic Installation  
Windows XP will display a  
Wireless Network Connec-  
tion message like this one.  
1. First, install the WG511 software.  
a. Power on your notebook, let the operating system boot up  
completely, and log in as needed.  
WG511 Resource CD.  
3. Now, configure your WG511.  
b. Verify that your Connection and Status Monitor information  
matches your wireless network.  
b. Insert the Resource CD for the WG511 into your CD-ROM  
drive. The CD index page shown below will load.  
a. Right click on the network icon in the Windows XP system  
tray to open the network options menu.  
c. Check the two LEDs on the WG511: green indicates a good  
connection; blinking green indicates attempting to connect;  
off indicates the card is not fully plugged in. Blinking for  
the amber LED indicates data transmission.  
Note: If this  
page does not  
automatically  
appear, double-  
click on  
INDEX.HTM on  
the CD to load  
this page.  
d. Verify connectivity to the Internet or network resources.  
b. Click on the View Available Wireless Networks menu item.  
Note: If you are unable to connect, see troubleshooting tips in  
the Basic Installation section of the Reference Manual on the  
NETGEAR 54 Mbps Wireless PC Card WG511 Resource CD.  
If there is more than  
one wireless network  
in your vicinity, click  
on the one to which  
you will connect.  
c. Click the INSTALL button. Read the instructions, then click  
the Install Software link. When the browser warning  
message appears, click Open to start the Install Shield.  
d. Follow the InstallShield Wizard steps, and click Finish  
when done to restart your computer.  
 

MTD Blower 241 688A User Manual
NEC Computer Monitor EA241WM User Manual
NEC Indoor Furnishings WMK3260 L User Manual
Network Technologies Switch UNIMUX USBV 4 User Manual
Oster Waffle Iron 3862 User Manual
Panasonic DVD VCR Combo DVD RV40 User Manual
Panasonic Network Card 2SA1532G User Manual
Panasonic Switch LK T Relays User Manual
Panasonic VCR AJ HD3700BP User Manual
Parkside Saw PPHSS 730 SE User Manual