Musical Fidelity Power Supply X PSUV8 X V8 User Manual

X-PSUV8  
X-V8 SERIES POWER SUPPLY UNIT  
INSTRUCTIONS FOR USE  
Thank you for purchasing the Musical Fidelity X-PSU V8.  
The X-PSU V8 is a high quality power supply unit designed to complement the X-V8 series components. It will  
conveniently drive up to four X-V8 series components from a single mains point with no compromise in  
performance.  
Dust regularly with a soft duster or soft brush, but be careful when using cleaning or polishing agents - they  
may harm the surface finish.  
If you have any questions about your audio system,  
Please consult your dealer who is there to help and advise.  
 
X-PSUV8  
SAFETY INFORMATION  
IMPORTANT! (U.K. only)  
This unit is supplied in the U.K. with mains lead fitted with a moulded 13 amp plug. If, for any reason, you need to cut  
off the plug, please remove the fuse holder and dispose of the plug safely, out of reach of children. It must not be  
plugged into a mains outlet.  
The wires in the mains lead supplied with this appliance are coloured in accordance with the following code:  
Green and yellow..............Earth  
Blue................................Neutral  
Brown.................................Live  
WARNING - This appliance MUST be earthed  
As the colours of the wires of the mains lead of this appliance may not correspond with the  
coloured markings identifying the terminals in your plug, proceed as follows:  
The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked with the  
letter E or coloured green or green-and-yellow, or by the earth symbol :  
The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.  
The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.  
If connecting to a BS1363 plug, a 13 amp fuse must be used.  
WARNING:  
ANY MODIFICATIONS TO THIS PRODUCT NOT EXPRESSLY APPROVED  
BY MUSICAL FIDELITY WHO IS THE PARTY RESPONSIBLE FOR  
STANDARDS COMPLIANCE COULD VOID THE USER'S AUTHORITY TO  
OPERATE THIS EQUIPMENT.  
Issue 1  
Page 3 of 10  
 
X-PSUV8  
GENERAL ADVICE  
INSTALLATION PRECAUTIONS and USER INFORMATION  
Your new X-PSUV8 is designed and built to provide trouble-free performance, but as with all electronic devices it is  
necessary to observe a few precautions:  
Heed all warnings shown on the back of the product.  
Always ensure that when disconnecting and reconnecting your audio equipment the mains supply is switched  
off.  
Position the mains lead and signal interconnects where they are not likely to be walked on or trapped by items  
placed on them.  
Do not use near water, or place water-filled containers on the X-PSUV8, for example, a flower vase or potted  
plants. If water does spill inside, immediately pull out the mains plug from the wall socket and inform  
your dealer, who should then check the unit before further use. Entry of liquid into the X-PSU V8 is  
dangerous, and may cause electric shock or fire hazard.  
Do not place the unit near direct heat sources such as radiators, direct sunlight or other equipment.  
Do not remove any covers or try to gain access to the inside. There are no internal adjustments or fuses you can  
replace yourself. Refer all service work to an authorised Musical Fidelity agent.  
Note: Unauthorised opening of the equipment will invalidate any warranty claim.  
Dust regularly with a soft cloth or soft brush but be careful when using cleaning or polishing agents - they may  
harm the surface finish.  
The electronics in modern hi-fi equipment is complex and may, therefore, be adversely affected or damaged by  
lightning. For protection of your audio system during electrical storms, remove the mains plugs and disconnect any  
aerial lead.  
If after-sales service is required, to help your dealer identify the X-PSUV8 please quote the serial number located on the  
rear panel of the unit.  
Issue 1  
Page 4 of 10  
 
X-PSUV8  
ITEM DISPOSAL INFORMATION  
DISPOSAL  
AFVAL  
The crossed out wheeled bin label that appears on the  
Het label op de achterzijde van dit apparaat, een  
afvalbak op wielen met een kruis doorgehaald, geeft aan dat dit  
apparaat niet samen met gewoon huishoudafval mag worden  
weggegooid. Om mogelijke schade aan onze leefomgeving te  
voorkomen dient dit apparaat, gescheiden van gewoon  
huishoudelijk afval, te worden afgevoerd zodat het op een  
milieuvriendelijke manier kan worden gerecycled. Neem voor  
beschikbare inzamelplaatsen contact op met uw gemeentelijke  
reinigingsdienst of met uw elektronica leverancier.  
back panel of the product indicates that the product must not be  
disposed of as normal household waste. To prevent possible harm  
to the environment please separate the product from other waste to  
ensure that it can be recycled in an environmentally safe manner.  
Please contact your local government office or your retailer for  
available collection facilities.  
DISPOSITION  
La poubelle sur roulettes barrées X, qui apparaît en logo  
sur le panneau arrière du produit, indique que celui-ci ne doit pas  
être traité comme un déchet domestique commun. Afin de protéger  
l'environnement, ce produit électronique devra être géré  
séparément et donc recyclé selon les nouvelles normes  
Européennes Rohs concernant les déchets d'appareils électroniques.  
Prière de contacter les services concernés gouvernementaux ou  
votre point de vente pour l'élimination et l'enlèvement de déchets  
électroniques équipés de composants électroniques.  
HÄVITTÄMINEN  
Yliruksattua jäteastiaa kuvaava tarra tuotteen  
takalevyssä kertoo, että tuotetta ei saa käsitellä normaalina  
talousjätteenä. Ympäristön suojelemiseksi on tuote pidettävä  
erillään muusta jätteestä ja se on kierrätettävä ekologisesti  
kestävällä tavalla. Ota yhteyttä laitteen myyjään tai Pirkanmaan  
Ympäristökeskukseen lähimmän kierrätyskeskuksen löytämiseksi.  
AFSKAFNING  
DISPOSAL  
Logoet med en skraldespand med kryds over på bagsiden  
af apparatet indikerer at dette produkt ikke må kasseres som normal  
husholdningsaffald. For at forebygge mulig skade på miljøet, bedes  
De separere dette produkt fra andet affald, og sikre at det bliver  
genbrugt på en miljørigtig måde. Kontakt venligst de lokale  
myndigheder eller din forhandler for oplysning om nærmeste  
tilgængelige opsamlingssted for elektronikaffald.  
La etiqueta cruzada hacia fuera del compartimiento que  
aparece en el panel trasero del producto indica que el producto no  
se debe reciclarse como basura normal de la casa. Para prevenir  
daños posible al ambiente separe por favor el producto de otras  
basura para asegurarse de que puede ser reciclada de una manera  
ambientalmente segura. Entre en contacto por favor a su oficina  
gubernamental local o a su minorista para las instalaciones  
disponibles de la colección.  
∆ΙΑ∆ΙΚΑΣΙΑ ΑΠΟΡΡΙΨΗΣ  
ΤΟ  
ΣΗΜΑ  
ΜΕ  
ΤΟΝ  
∆ΙΑΓΕΓΡΑΜΜΕΝΟ  
RIFIUTI  
ΤΡΟΧΗΛΑΤΟ ΚΑ∆Ο ΑΠΟΡΡΙΜΑΤΩΝ ΣΤΗΝ ΠΙΣΩ ΟΨΗ  
ΤΟΥ ΜΗΧΑΝΗΜΑΤΟΣ  
L'etichetta del cassonetto barrato riportato sul retro  
dell'apparecchio indica che il prodotto non deve essere smaltito  
tramite la procedura normale di smaltimento dei rifiuti domestici.  
Per evitare eventuali danni all'ambiente, separare questo prodotto  
da altri rifiuti domestici in modo che possa venire riciclato in base  
alle procedure di rispetto ambientale. Per maggiori dettagli  
sulle aree di raccolta disponibili, contattate l'ufficio govenativo  
locale od il rivenditore del prodotto.  
∆ΗΛΩΝΕΙ ΟΤΙ ΤΟ ΠΡΟΙΟΝ ΑΥΤΟ ∆ΕΝ ΠΡΕΠΕΙ ΝΑ  
∆ΙΑΧΕΙΡΙΣΘΕΙ ΣΑΝ ΣΥΝΗΘΙΣΜΕΝΟ ΟΙΚΙΑΚΟ ΑΠΟΒΛΗΤΟ.  
ΠΡΟΣ ΑΠΟΦΥΓΗ ΕΝ∆ΕΧΟΜΕΝΗΣ ΕΠΙΒΑΡΥΝΣΗΣ ΤΟΥ  
ΠΕΡΙΒΑΛΛΟΝΤΟΣ, ΞΕΧΩΡΙΣΤΕ ΤΟ ΠΡΟΙΟΝ ΑΠΟ ΤΑ  
ΑΛΛΑ  
ΑΠΟΡΡΙΜΑΤΑ ΩΣΤΕ ΝΑ ΕΞΑΣΦΑΛΙΣΘΕΙ Η ΑΝΑΚΥΚΛΩΣΗ  
ΤΟΥ ΜΕ ΤΟΝ ΠΡΕΠΟΝΤΑ ΤΡΟΠΟ.  
ΠΑΡΑΚΑΛΟΥΜΕ ΝΑ ΕΠΙΚΟΙΝΩΝΗΣΕΤΕ ΜΕ ΤΗΝ ΤΟΠΙΚΗ  
FACHGERECHTE ENTSORGUNG:  
ΥΠΗΡΕΣΙΑ ΑΝΑΚΥΚΛΩΣΗΣ  
Η
ΜΕ ΤΟ ΚΑΤΑΣΤΗΜΑ  
Das auf der Geräterückseite angebrachte Label deutet  
darauf hin, dass das Produkt nicht mit konventionellem  
Hauskehricht entsorgt werden darf. Um Schäden und  
Verschmutzungen an Umwelt und Mensch zu vermeiden, muss das  
Produkt fachgerecht entsorgt und von anderem Abfall getrennt  
werden. Wenden Sie sich bei Fragen hierzu an Ihren Fachhändler  
oder an eine öffentliche Informationsstelle.  
ΑΓΟΡΑΣ ΓΙΑ ΠΕΡΙΣΣΟΤΕΡΕΣ ΛΕΠΤΟΜΕΡΕΙΕΣ.  
Issue 1  
Page 5 of 10  
 
X-PSUV8  
INSTALLATION  
INTRODUCTION  
INSTALLATION  
Congratulations on the purchase of your new X-PSUV8  
power supply unit.  
Position the X-PSUV8 on a stable, horizontal surface  
where there is no risk of it being knocked, or subjected  
to vibration such as from loudspeakers.  
The X-PSUV8 complements our compact integrated Hi-  
Fi range, powering a set of our mini-separates from one  
convenient box.  
CONNECTIONS  
The unit will control power to all units connected to it  
through one on/off switch, and only needs one wall  
socket for up to four components.  
Outputs: With the unit switched off, connect your  
components to the DIN sockets, on the back panel.  
Once all components are connected to the power supply  
unit, wire them as required with interconnect cables, and  
check wiring.  
Connect the unit to the mains using supplied lead.  
Switching on the power supply unit should light the  
front panel power LED and the connected components  
should all come on. The setup is then ready for use.  
CLEANING  
Before cleaning the unit, switch off power at the mains  
switch and remove the mains plug from the wall socket.  
Clean the cabinet and remote control unit using a moist  
cloth. We do not advise using solvents, white spirit or  
thinners as they could damage the surface finish.  
Issue 1  
Page 6 of 10  
 
X-PSUV8  
FACILITIES AND CONNECTION  
FRONT PANEL  
1
1. POWER Indicator LED  
REAR PANEL  
2
3
4
2. MAINS power switch  
4. XV8 independent power outlet sockets  
3. IEC MAINS Input  
Issue 1  
Page 7 of 10  
 
X-PSUV8  
POWER SUPPLY PROBLEMS?  
Basic problem-solving with an amplifier is similar to troubleshooting other electrical or electronic equipment. Always  
check the most obvious possible causes first, such as the following examples:  
Problem  
Probable Cause  
Remedy  
No power when POWER button is  
Mains power plug is not fully inserted Plug in securely.  
pressed  
into rear socket  
Check mains cable.  
No response from connected  
component(s)  
Component(s) not connected or  
plug(s) not securely fitted.  
Check plug(s) are securely seated.  
No mains connection  
Power switch is off  
Check mains cable  
Push switch to switch on units.  
If none of these actions affect a cure, please contact your dealer, or an authorised Musical Fidelity service agent.  
Remember; never open the case of the X-PSU V8 yourself, as this will invalidate the guarantee.  
Issue 1  
Page 8 of 10  
 
X-PSUV8  
POWER SUPPLY SPECIFICATIONS  
Connections:  
Power outputs:  
4 off 3 way DIN socket  
Power requirement:  
100W maximum  
Weight:  
3.0 kg,  
4.3 kg,  
6 ¾ lbs  
11.2 lbs  
unit only, unboxed  
in shipping carton  
Dimensions: 180 mm,  
88 mm,  
7.1 inches  
3.5 inches  
9.3 inches  
wide  
high including feet  
deep including terminals (total 320mm, 12.6 inches with plugs in)  
235 mm,  
Standard accessories:  
10A IEC Mains lead  
Musical Fidelity reserves the right to make  
improvements which may result in specification or  
feature changes without notice.  
Issue 1  
Page 9 of 10  
 
X-PSUV8  
MANUAL REVISION  
RELEASE  
DATE  
CHANGES  
Issue 1  
30th October 2007  
Issue 1  
Page 10 of 10  
 

Miele Oven H 5981 BP User Manual
Miele Washer W 970 User Manual
Mr Coffee Coffeemaker ECMP50 User Manual
Multi Tech Systems Network Card MTCBA C U User Manual
Nady Systems Microphone SCM 800 User Manual
Nady Systems Microphone SCM 2090 User Manual
Nextar MP3 Player N10W 400 User Manual
Oki Printer 24 Series User Manual
Panasonic Cordless Drill EY503B User Manual
Panasonic DVD Player DVD S55 User Manual