Moultrie Welder Welder User Manual

Instructions for Pro-Line Directional Feeder  
THANK YOU for your purchase of the Pro-Line Directional Feeder  
Kit, a top quality Moultrie product. Please read both sides of this sheet  
before operating this unit. If you should have any questions about this or  
any other Moultrie product, please contact us using the information on the  
reverse side. To help us to better serve you, please complete and mail  
the enclosed Warranty Card.  
DRILLING YOUR DRUM/BARREL/BUCKET  
Funnel Holes  
Directional Feeder will mount to the bottom of any drum or bucket.  
caut i on: wear eye pr ot ect i on  
Turn drum over, measure and mark the center of the bottom.  
Center the template on the bottom of the drum and secure  
with tape. Drill two 3/16" Funnel holes and three 5/16"  
Feeder Leg holes.  
Using a Hole Saw, drill a 2-1/4" hole in the center of the  
bottom of your drum.  
Feeder Leg Holes  
MOUNTING THE FEEDER  
Short  
Bolts  
Bolts  
Place Funnel inside Drum with  
small end of funnel facing down.  
Attach with two Short Bolts  
using nuts and washers provided.  
Drum  
Turn Drum upside down.  
Funnel  
Place Feeder on Drum. Attach  
Feeder Legs to drum as shown  
with large Bolts using nuts and  
washers provided.  
Feeder  
Long  
Bolts  
Feeder Legs  
Drum  
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC rules. These limits are designed  
to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if  
not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference  
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the  
equipment off and on, the user is encouraged to correct the interference by one or more of the following measures:  
Reorient or relocate the receiving antenna Increase the separation between the equipment and the receiver  
 

Miele Washer W828 User Manual
Muratec Printer MFX 1450 User Manual
NEC Laptop Versa VX User Manual
Nikon Camera Lens 105mm f 28G ED IF DX User Manual
Nortel Networks Network Card 703t User Manual
Nortel Networks Switch 8006 User Manual
Omega Vehicle Security Switch LVP 51 Series User Manual
OWI Speaker JL 8 User Manual
Panasonic Electric Shaver ESRF 41 User Manual
Parrot Bluetooth Headset MK6100 User Manual