Miele Oven DGC 4084 XL User Manual

Installation Instructions  
Combi-Steam Oven  
DGC 4084 XL  
DGC 4086 XL  
en - US, CA  
To prevent accidents  
and appliance damage  
read these instructions  
before  
installation or use.  
M.-Nr. 09 064 870  
 
IMPORTANT INSTALLATION SAFETY INSTRUCTIONS  
Be certain your appliance is  
~
properly installed and grounded by a  
,WARNING - Read all instructions  
before installation or use of the  
steam oven to prevent injury and  
machine damage.  
qualified technician. To guarantee the  
electrical safety of this appliance,  
continuity must exist between the  
appliance and an effective grounding  
system. It is imperative that this basic  
safety requirement be met. If there is  
any doubt, have the electrical system of  
the house checked by a qualified  
electrician.  
Installation, repair and maintenance  
~
work should be performed by a Miele  
authorized service technician. Work by  
unqualified persons could be  
dangerous.  
Before installation make sure that  
Do not use an extension cord to  
~
~
the voltage and frequency listed on the  
data plate correspond with the  
connect this appliance to electricity.  
Extension cords do not guarantee the  
required safety of the appliance, (e.g.  
danger of overheating).  
household electrical supply. This data  
must correspond to prevent injury and  
machine damage. Consult a qualified  
electrician if in doubt.  
Make sure that the outlet is easily  
~
accessible after installation of the  
appliance.  
Before installation, check the  
~
appliance for visible signs of damage.  
Do not install or operate a damaged  
unit.  
This appliance must not be used in  
~
a non-stationary location (e.g. on a  
ship).  
Do not operate any appliance with a  
~
The appliance must be installed so  
~
damaged cord or plug or if the  
appliance has been damaged in any  
manner.  
that the user can access all cooking  
levels and containers. Otherwise you  
may risk scalding or burning yourself  
with hot water and food when taking  
containers out of the oven.  
Before installation or service,  
~
disconnect the power supply to the  
work area by removing the fuse,  
"tripping" the circuit breaker or  
switching off the power main. Ensure  
that power is not restored to the  
appliance during maintenance or repair  
work.  
Keep these operating instructions in  
~
a safe place and pass them on to any  
future user  
Note to the installer:  
Please leave these instructions with the  
consumer of the appliance for the local  
building inspectors use.  
Do not tamper with electrical  
~
connections and components or  
mechanical parts. Never open the outer  
casing of the appliance.  
SAVE THESE  
INSTRUCTIONS  
3
 
Installation  
Miele appliances can be installed flush or proud. Discuss your installation  
requirements with your architect, designer or installer.  
Dimension details of the appliance front  
7/8"  
22*/23**  
17/8"  
47,5  
-2  
4
 
Installation  
Dimension to allow the control  
panel to open and close  
The area in front of the control panel  
must not be blocked by anything (such  
as a door handle) this would hinder the  
control panel from opening and closing.  
5
 
Installation  
Cut-out for venting the combi-steam oven  
Installation in a tall cabinet  
15/8"  
195/8"  
(40 mm)  
(500 mm)  
a
b
To ensure that the combi-steam oven has adequate ventilation, the following  
cut-outs measuring 19 11/16" x 1 9/16" (500 x 40 mm) must be provided:  
ain the top of the cabinet  
bin the center shelf above the installation niche  
If installing in combination with an oven please refer to the installation  
instructions included with the oven for oven venting instructions.  
6
 
Installation  
Installation under a countertop  
19 5/8"  
(500 mm)  
a
5/8"  
1
(40 mm)  
b
To ensure that the combi-steam oven has adequate ventilation, the following  
cut-outs measuring 19 11/16" x 1 9/16" (500 x 40 mm) must be provided:  
ain the appliance support shelf  
bin the bottom of the cabinet space below it  
7
 
Appliance and installation dimensions  
Installation in a tall cabinet  
195/8"  
(500 mm)  
5/8"  
1
(40 mm)  
d
b
c
21  
7/8"  
215/8"  
(549 mm)  
e
1/16" 3/8"  
a
22  
- 22  
21  
(547 mm)  
1/2"  
7/16"  
23  
(560 mm  
- 568 mm)  
(595 mm)  
(22 mm*/  
7/8"  
23 mm**)  
aCombi-steam oven  
b Installation niche  
cTerminal block  
dOutlet or junction box  
This should be accessible after the appliance has been installed.  
ePower cord (5 ft.)  
* Appliances with glass front / ** Appliances with metal front  
8
 
Appliance and installation dimensions  
Installation under a countertop  
If the appliance is be installed under a cooktop, observe the installation  
instructions for the cooktop and its installation height.  
d
195/8"  
(500 mm)  
21  
7/8"  
( 555 mm)  
0
c
215/8"  
(549 mm)  
e
5/8"  
1
(40 mm)  
3/8"  
- 22  
1/16"  
22  
(560 mm - 568 mm)  
b
a
21  
(547 mm)  
1/2"  
7/16"  
23  
(595 mm)  
(22 mm*/  
7/8"  
23 mm**)  
aCombi-steam oven  
bInstallation niche  
cTerminal block  
dOutlet or junction box  
This should be accessible after the appliance has been installed.  
ePower cord (5 ft.)  
* Appliances with glass front / ** Appliances with metal front  
See the "Dimension to allow the control panel to open and close" section of this  
manual to ensure the countertop will not hinder the control panel from opening  
and closing.  
9
 
Appliance and installation dimensions  
Installation in combination with an oven  
195/8"  
(500 mm)  
5/8"  
1
(40 mm)  
d
221/16"  
- 22  
(560 mm  
(22 mm*  
/23 mm**)  
3/8"  
b
211/2"  
(547 mm)  
7/8"  
- 568 mm)  
21  
7/8"  
( 555 mm)  
0
215/8"  
(549 mm)  
c
e
7/16"  
23  
(595 mm)  
221/16"  
3/8"  
- 22  
(560 mm  
- 568 mm)  
a
f
7/16"  
7/8"  
(22 mm*/  
23 mm**  
23  
(595 mm)  
)
aCombi-steam oven  
bInstallation niche  
cTerminal block  
dOutlet or junction box  
This should be accessible after the appliance has been installed.  
ePower cord (5 ft.)  
fOven  
* Appliances with glass front / ** Appliances with metal front  
See the "Cut-out for venting the combi-steam oven" section of this manual for  
more information on venting the combi-steam oven.  
10  
 
Appliance and installation dimensions  
Installation in combination with ESW 408x-14  
5/8"  
19  
(500 mm)  
5/8"  
1
(40 mm)  
d
b
7/8"  
c
21  
7/8"  
(22 mm*  
/23 mm**)  
215/8"  
(549 mm)  
221/16"  
3/8"  
- 22  
(560 mm  
7/16"  
e
-
- 568 mm)  
3/8"  
23  
a
21  
(547 mm)  
1/2"  
7/16"  
23  
(595 mm)  
3 / 1 6 "  
5
1/8"  
21  
(537 m
(
1
3
1
m
m
)
9/16"  
5
21  
7/16"  
(548 9m/1m6")  
1/8"  
(3 mm)  
23  
(595 mm)  
(7 )  
(22*/23**mm  
1/4"  
7/8"  
)
aCombi-steam oven  
bInstallation niche  
cTerminal block  
dOutlet or junction box  
This should be accessible after the appliance has been installed.  
ePower cord (5 ft.)  
fBuilt-in plate warmer / built-in food warmer  
* Appliances with glass front / ** Appliances with metal front  
See the "Cut-out for venting the combi-steam oven" section of this manual for  
more information on venting the combi-steam oven.  
11  
 
Appliance and installation dimensions  
Installation in combination with ESW 408x-14 BRWS  
195/8"  
(500 mm)  
(40 mm)  
5/8"  
1
d
b
7/8"  
c
21  
7/8"  
(22 mm*  
/23 mm**)  
215/8"  
(549 mm)  
221/16"  
3/8"  
- 22  
(560 mm  
7/16"  
e
-
- 568 mm)  
3/8"  
23  
a
21  
(547 mm)  
1/2"  
7/16"  
23  
(595 mm)  
3 / 1 6 "  
5
1/8"  
21  
(537 m
(
1
3
1
m
m
)
9/16"  
5
21  
7/16"  
(548 9m/1m6")  
1/8"  
(3 mm)  
23  
(595 mm)  
(4 )  
(22*/23**mm)  
1/8"  
7/8"  
aCombi-steam oven  
bInstallation niche  
cTerminal block  
dOutlet or junction box  
This should be accessible after the appliance has been installed.  
ePower cord (5 ft.)  
fBuilt-in plate warmer / built-in food warmer  
* Appliances with glass front / ** Appliances with metal front  
See the "Cut-out for venting the combi-steam oven" section of this manual for  
more information on venting the combi-steam oven.  
12  
 
Appliance and installation dimensions  
Installing the appliance  
^ Push the appliance into the cabinet niche and align it.  
The device must be level, so that the steam generator can  
operate properly.  
Deviation from a horizontal position should not exceed 2°.  
^ Secure the appliance by screwing the two 3.5 x 25 mm  
wood screws (supplied) into the vertical strips on either  
side of the housing.  
13  
 
Electrical connection  
Power supply  
,CAUTION: Before installation or  
servicing, disconnect the power  
supply by either removing the fuse,  
shutting off the main power or  
manually "tripping" the circuit  
breaker.  
Installation, repairs and other work  
by unqualified persons could be  
dangerous.  
^ Be sure your electrical supply  
matches the data plate.  
Installation work and repairs should  
only be performed by a qualified  
technician in accordance with all  
applicable codes and standards.  
Repairs and service by unqualified  
persons could be dangerous.  
The appliance is equipped with a 5 ft.  
(1.5 m) flexible power cord encasing 3  
wires ready for hardwiring to a 240 V,  
20 A, 60 Hz grounded power supply.  
It must be connected to a dedicated  
line through the use of an approved  
junction box.  
Before connecting the appliance to  
the power supply, make sure that  
the voltage and frequency listed on  
the rating label correspond with the  
household electrical supply. This  
data must correspond to prevent  
appliance damage.  
A disconnection incorporated in the  
fixed wiring must be provided. There  
must be an all-pole contact gap of at  
least 3 mm in the isolator switch  
(including switch, fuses and relays).  
Black wire: connect to L1 (hot)  
Red wire: connect to L2 (hot)  
Only operate the appliance after it  
has been installed.  
Green wire: connect to GND (ground)  
For further information, see the wiring  
diagram provided with the appliance.  
If there is any question concerning  
the electrical connection of this  
appliance to your power supply,  
please consult a licensed electrician  
or contact Miele’s Technical Service  
Department.  
,WARNING:  
THIS APPLIANCE MUST BE  
GROUNDED!  
Installer:  
Please leave these instructions with  
the consumer.  
14  
 
15  
 
Alteration rights reserved / 1013  
M.-Nr. 09 064 870 / 03  
INFORMATION IS SUBJECT TO CHANGE. PLEASE REFER TO OUR WEBSITE TO OBTAIN THE MOST  
CURRENT PRODUCT SPECIFICATIONS, TECHNICAL & WARRANTY INFORMATION.  
 

NeumannBerlin Microphone CMV 3 User Manual
Nextar MP3 Player MA201 User Manual
Nissan Paint Sprayer Z33 D User Manual
NordicTrack Treadmill NTTL17900 User Manual
Novatel Network Card GM 14915118 User Manual
Oakley Watch Holeshot 3 Hand User Manual
Oregon Scientific Fitness Electronics PE980 User Manual
Palsonic Flat Panel Television TFTV515 User Manual
Palsonic Flat Panel Television TFTV663R User Manual
Panasonic Cell Phone EB X70 User Manual