Miele Food Warmer ESW 47XX User Manual

Installation Instructions  
ESW 47xx  
ESW 48xx en_CA  
Installation, repair and maintenance work should be performed by  
a Miele authorized service technician in accordance with national  
and local safety regulations and the provided installation instructions.  
 
Installation  
Installation tips  
Steam from the vents can damage  
the cabinetry surrounding the  
warming drawer.  
– The warming drawer should be  
placed at a convenient height for  
easy access.  
– The drawer should be installed clear  
of drafts caused by open doors and  
windows.  
Solo Installation:  
A minimum gap of 2" (5 cm) must be  
present between the upper edge of  
the warming drawer and the  
cabinetry.  
– Proper clearance must be allowed  
for the warming drawer to open with  
out interference.  
Installation in combination with an  
oven:  
A minimum gap of 1" (2.5 cm) must  
be present between the upper edge  
of the warming drawer and the oven.  
– The warming drawer must be  
secured to cabinetry to prevent the  
drawer from tipping when loaded.  
– The warming drawer should be level  
to prevent the drawer from sliding  
open or closing on its own.  
This gap should be sealed with a  
moisture resistant sealing material.  
The drawer cannot be leveled after it  
has been installed.  
If necessary install a shelf within the  
cabinetry to support the drawer.  
26  
 
Installation  
Dimensions for Solo Installation  
ESW 47x0  
a Material must be moisture resistant  
Miele appliances can be installed ꢀush or proud. Discuss your  
installation requirements with you architect, designer and installer.  
27  
 
Installation  
ESW 48x0  
a
24"  
(610)  
281/2"  
26"-  
(660-724)  
2"  
1/8"  
10  
15/16"  
( 2 8 0 )  
1
25  
(659)  
3
9
22 15/16"  
(582)  
13/16"  
29  
(757)  
1"  
(26)  
a Material must be moisture resistant  
28  
 
Installation  
Dimensions for a combination installation with an oven  
ESW 47x0  
a Material must be moisture resistant  
1
7
( 5 8 0 )  
( 5 9 6 )  
23  
a
1/8"  
1
1
1
1
1
( 2 8 0 )  
10  
3/8"  
3/16"  
29  
 
Installation  
ESW 48x0  
a Material must be moisture resistant  
30  
 
Installation  
Installing the warming drawer  
^ Push the casing in the cabinetry.  
^ Remove the drawer from the casing  
before installing the appliance into  
the cabinetry.  
Removing the drawer  
^ Secure the casing in the cabinetry  
with the six screws.  
Inserting the drawer  
^ Pull out the telescopic skis from the  
casing.  
^ Pull the drawer completely out and  
loosen the nuts.  
^ Set the drawer on the telescopic skis  
and secure with the two nuts.  
^ Carefully lift the drawer and pull it  
slowly out.  
Set the drawer down on a flat, stable  
surface.  
31  
 
Installation  
Integrated installations  
Models 4700 FB and 4800 FB  
a Install a handle to the custom front  
panel using counter sunk screws.  
b Remove the drawer from the casing.  
Custom made front panels can be  
installed with models 4700 FB and  
4800 FB.  
See "Removing the drawer".  
The panel attached to the warming  
drawer front can be used as the drilling  
template for the custom panel.  
Panel dimensions  
4700 FB  
Width 27 3/8" (695 mm)  
Height 11" (279 mm)  
4800 FB  
Width 29 13/16" (757mm)  
Height 11" (279 mm)  
The custom panel must be atleast 3/8"  
(10 mm) thick and made of heat resist-  
ant material140 °F (60 °C).  
c Loosen the two screws on the inner  
side of the drawer and remove the  
panel from the appliance front.  
d Place the panel on a firm surface  
with the adhesive tape facing up.  
Peel the backing from the adhesive  
tape.  
e Position the custom panel over the  
removed panel using the tape to hold  
it in place.  
32  
 
Installation  
f Press the custom panel tightly onto  
h Hook the panels into the bottom on  
and secure at the top with two  
screws making sure the seal is  
seated correctly.  
the removed panel.  
g Screw the removed panel to the  
custom panel with the eight screws.  
33  
 
Alteration rights reserved / 3206  
M.-Nr. 06 543 320 / 06  
en - US  
 

Multiquip Music Mixer WM 700P User Manual
Multiquip Portable Generator DCA 150SSJU3 User Manual
NAD Stereo Receiver 7140 User Manual
NEC Computer Monitor EA191M BK User Manual
NETGEAR Modem GS116 User Manual
Nikon Network Card WT 2 User Manual
Oki Copier B4545 User Manual
Omnimount TV Mount OM10059 User Manual
Panasonic Network Card 2SD1823 User Manual
Patton electronic Modem 1005 User Manual