Miele Coffeemaker CVA 4070 EN CA User Manual

Installation Instructions  
CVA 4070 en-CA  
Installation, repair and maintenance work should be performed by  
a Miele authorized service technician in accordance with national  
and local safety regulations and the provided installation instructions.  
 
Installation  
Installation options  
The coffee system is designed to be built into cabinetry.  
A combination with other Miele built in appliances is possible. If the machine is installed  
in combination with other appliances, it should be installed with a protective base  
between the appliance and the unit (exception: installation with a built-in plate warmer).  
A special display cabinet is also available from your dealer or Miele, as an installation option.  
Miele appliances can be installed ꢀush or proud. Discuss your installation  
requirements with your architect, designer and installer.  
58  
 
Installation  
Installation  
^ If your cabinet has 3/4" (19 mm) side  
walls, drill four holes for the  
mounting.  
Make sure power is not supplied to  
the appliance while installation or  
maintenance work is performed.  
Disconnect the power supply to the  
work area by unplugging the unit,  
tripping the circuit breaker or  
removing the fuse. The coffee  
system must be installed into  
cabinetry before being used.  
^ Center the unit and turn the screws a  
little bit in and then out again.  
^ Take the unit out of the niche and drill  
four holes at the screw markings  
(1/16" [2 mm], diameter 3/16"  
[4.5 mm]).  
^ Connect the appliance to a cold  
water supply.  
^ Plug the appliance into the electrical  
outlet.  
^ Push the appliance into the niche.  
^ Unscrew the height adjustable feet  
on the underside of the machine  
about 1/16" (2 mm).  
^ Push the appliance all the way back  
into the cabinet and center it. If  
necessary level the unit with the four  
height adjustable feet.  
^ Open the door and partially tighten  
the screws.  
The feet can be turned out up to 3/8"  
(10 mm).  
^ Carefully turn the lower screws, a, to  
center the machine.  
^ To secure the appliance in the  
cabinet, tighten the upper screws, b,  
by hand. Do not use an electric  
screwdriver.  
59  
 
Installation  
Adjusting the door hinges  
The door hinges can be adjusted if the  
door cannot be opened easily.  
^ To adjust the door sideways, a, turn  
screw a.  
^ To adjust the door to the front or  
back, b, turn screw b.  
60  
 
Alteration rights reserved / 0607  
CVA 4070  
M.-Nr. 06 911 520 / 02  
en - USA / CDN  
For the most updated manual see the MIele Website.  
 

Miele Refrigerator F 1471 User Manual
Milwaukee Power Hammer 1 1 2 User Manual
MTD Blower 249 688A User Manual
Nady Systems Microphone IRW 2PA User Manual
NEC Amplified Phone ND 70895 E User Manual
Oki Printer 5800dn User Manual
Omega Vehicle Security Stud Sensor OM 40 C HT User Manual
Omnimount TV Mount 1004164 User Manual
Panasonic Network Card 2SA1790G User Manual
Parrot GPS Receiver 3200LS User Manual